Nortec 132-3091 Installation, Operation And Maintenance Manual

guide to be left with equipment owner. Form #03-172 1506262 ...

INSTALLATION 1 RECEIVING & UNPACKING EQUIPMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 PRE-INSTALLATION CHECKPOINT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 BASIC HUMIDIFIER CONFIGURATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 LOCATION & MOUNTING . . . . . ...

HOW TO REMOVE THE STEAM CYLINDER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 MANDATORY CLEANING OF THE DRAIN VALVE . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 HOW TO INSTALL THE REPLACEMENT CYLINDER . . . . . . . . . ...

1. Check packing slip to ensure ALL material has been delivered. 2. All material shortages are to be reported to NORTEC within 48 hours from receipt of goods. NORTEC assumes no responsibility for any material shortages beyond this period. 3. Inspect shipping boxes for damage and note on shipping waybill accordingl ...

HUMIDIFIERS NH Series humidifiers are designed to mount on a suitable wall or vertical surface. Do not sit on floor due to clearances required for plumbing, electrical, and control entrances. The clearance dimensions shown in this manual are for reference only and are the minimum required for maintenance of the humidifier. Local and Natio ...

blower pack gets overheated. Control thermostat, mounted on the steam distributor, starts the fan when steam is generated. When supply voltage differs from voltage required to run blower motor, blower pack will contain a proper transformer. All blower packs provide intake air filters. For installation detai ...

or gently sloped drain lines but it can not compensate for flat or uphill runs. 2. The drain line should not end in a sink used frequently by personnel, or where plumbing codes prohibit it. Route to a floor drain or equivalent for safety reasons, since drain water from humidifier can be very hot. 3. Keep drain ...

On-Off Controls Controls are available from NORTEC as accessories. If controls were not ordered with humidifier, they must be purchased supplied by others. The following information is relevant to all controls, factory supplied or otherwise. A, B and C (described below) are to be wired in series (only one path for current) across t ...

L1 L2 Ground Ground Wire Ground Leg 2 Pole Terminal Block Dedicated Circuit Breaker Or Disconnect - Single Phase Unit. - Single Phase Supply. - Required Voltage Between L1 And L2. - Load Balanced. L1 L2 Ground Ground Wire Ground Leg 2 Pole Terminal Block - Single Phase Unit. - 3 Phase Supply. - Required Voltage Between L1 And L2. - Load Will Be Unbalan ...

to be made to external side of terminals 26, 28, 30 and 32 on humidifier’s control terminal strip. Always refer to the external control’s wiring diagram factory supplied with each NORTEC modulation control option. 6. Varying dc Voltage Modulation Signal Powered by Others: NHMC/NHP Series humidifier c ...