Roberts Longneck 6 Owner's Manual

Text of the manual

LONGNECK 6"Jamb Saw

OWNER’S MANUAL Scie de Jambage de 150mm LONGNECK MANUEL D’UTILISATION Sierra de 150mm para Recortar Jambas LONGNECK MANUAL DE OPERACIÓN WARNING Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious bodily injury. SAVE THESE INSTRUCTIONS FOR FUTURE

WORK AREA: Keep your work area clean and well lit. Cluttered and dark work areas invite accidents.

Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. Keep bystanders, children, and visitors away while operating a power tool. D

GENERAL SAFETY RULES CONTINUED

MAINTENANCE: After use, check tool to keep it in top condition. 1. Clean out accumulated dust. 2. Check the brushes periodically for wear and replace both brushes when either is worn to about 1/3 in length. DO NOT MAKE ANY ADJUSTMENT WHILE THE MOTOR IS IN MOTION! WARNING KEEP SAFETY GUARDS IN PLACE TO AVOID POSSIBLE SERIOUS INJ

ASSEMBLY AND BLADE CHANGING

1. Make sure the saw is unplugged. 2. Insert the blade clamp into the saw blade arbor hole, so the blade clamp is securely seated in the blade. * Make sure the blade teeth are facing the direction of rotation (counterclockwise viewed from the bottom). 3. Insert the blade retainer screw, with the saw blade centered, into the saw ar

REGARDING WOOD BASE MOLDINGS

While some flooring installers trim wood base molding with jamb saws, it is not a recommended practice. Professional Flooring and Trade Associations recommend that the base molding be removed then replaced after the new floor is installed. This results in a better looking installation and preserves the height and appearance of th

LONGNECK 6" JAMB SAW

REPLACEMENT PARTS LIST Part Description 10-46-01 Handle 10-55-02 Allen® Wrench 10-46-03 Depth Gauge 10-46-04 Return Spring (3 pack) 10-46-05 Screws, Spacers, Spring (2 pack) 10-46-07 Handle Bolt & Lock Washer 10-46-08 Mounting Body 10-46-09 Height Adjustment Skirt 10-46-10 Screw Knob, Washer for Depth Gauge 10-46-11 Safety

RÈGLES GÉNÉRALES DE SÉCURITÉ

ZONE DE TRAVAIL: Garder la zone de travail propre et bien éclairée. Les zones de travail encombrées et sombres invitent les accidents. Ne pas faire fonctionner des outils électriques dans des atmosphères explosives, tel qu’en présence de liquides, de gaz ou de poussières inflammables. Les outils électriques créent

RÈGLES GÉNÉRALES DE SÉCURITÉ MAINTENU

SERVICE: La révision de l’outil ne doit être effectuée que par le personnel de service qualifié. La révision ou l’entretien effectués par des personnes non qualifiées pourrait entraîner des risques de blessures. Lors de la révision d’un outil, n’utiliser que des pièces de rechange identiques. Suivr

MONTAGE ET REMPLACEMENT DE LA LAME

1. S’assurer que la scie soit débranchée. 2. Insérer la griffe dans le trou du mandrin de la lame de façon à ce que la griffe de la lame soit bien appuyé dans la lame. * S’assurer que les dents de scie soient dirigées en direction de la rotation (dans le sens antihoraire si l’on regarde à partir du bas). 3. In

Other Saw Manuals