Nortel Ethernet Routing Switch 8010 Installation Manual

April 2000 4401 Great America Parkway Santa Clara, CA 95054 Installing the Passport 8010 Chassis ...

All rights reserved. April 2000. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility fo ...

Voluntary Control Council for Interference (VCCI) Statement Taiwan Requirements Bureau of Standards, Metrology and Inspection (BSMI) Statement Canada Requirements Only Canadian Department of Communications Radio Interference Regulations This digital apparatus (Passport 8010 Chassis) does not exceed the Class A limits for ra ...

This guide provides information about installing and using the Passport™ 8010 Chassis. It includes the following information: • Requirements for the operating environment of the chassis • Instructions for attaching rack-mounting brackets • Instructions for installing the chassis • Instructions for installing one or more power sup ...

The physical requirements for installing the Passport 8010 Chassis in an equipment rack are: For table or shelf installation, make sure the surface will support at least 225 pounds (101 kilograms). Make sure the area where you will install and use the Passport 8010 Chassis meets these environmental requirements: • Adequate room (13.1 spa ...

2 = Power Supply (one or more—ordered separately) 3 = Documentation 4 = Power cord (optional) 5 = DB-25 to DB-9 adapter for use with comm port cable 6 = Comm port cable for Passport 8132TX module, purchased separately 7 = Rack mounting brackets 8 = Screws for brackets and equipment rack 9 = Cable guides For detailed in ...

Required tool: Phillips screwdriver 1. Hold each rack-mounting bracket against one side of the chassis. Make sure the attachment holes in the bracket match the holes in the chassis. 2. Insert the supplied flat-head screws to fasten each bracket to the chassis. Note: Each bracket fits only one side of the chassis. If the ...

Required tool: Phillips screwdriver 1. Slide the chassis into the rack. 2. Insert and tighten the rack-mounting screws. To complete the installation process, refer to “Installing the Power Supply.” 9074FA 9075FA ...

Required tool: Phillips screwdriver 1. If necessary, remove the filler panel from a power supply bay. 2. Push the supply firmly into the bay. 8957FA 8958FA Note: If you are installing a power supply in a new chassis, be sure to remove the bag of dessicant from the middle power supply bay. 3. Align and tighten the retaining screw ...