ZKTeco X7 System User Manual

Text of the manual

Produced by ZKTeco Inc.

System User Manual X7 Access Control Поставщик систем безопасности: TELECAMERA.RU

Wall mount installation

Access Control System Function: (1)If a registered user verified, the device will export the signal to unlock the door. (2)Door sensor will detect the on-off state. If the door is unexpected opened or improperly closed, the alarm signal (digital value) will be triggered. (3)If the device being illegally removed, the device will exp

Warning: No operation when power on!

(1) The system supports NO LOCK and NC LOCK. For example the NO LOCK (normally open at power on) is connected with ‘NO’ terminal, and the NC LOCK is connected with ‘NC’ terminal. (2) When the Electrical Lock is connected to the Access Control System, you need to parallel one FR107 diode (equipped in the package

Voltage output ≤ DC 12V for Alarm

Input DC 12V, 500mA (50mA standby) Positive is connected with ‘+12V’, negative is connected with ’GND’ (do not reverse the polarities). 4. Connected with Other Parts 5. Connect with Power Поставщик систем безопасности: TELECAMERA.RU

Step 1: Install the device and power on.

Step 2: After the administrator password is authenticated and changed, register users' fingerprints, cards, or passwords. Step 3: Configure access control parameters, including modifying eight passwords for opening the door and configuring the unlocking duration, authentication mo

1. User Management

1.1 Administrator Operations To ensure data security of the device, you can operate the device only after the administrator password is authenticated.  Administrator Authentication 1. Press [*] (The indicator is off and makes a long beep.) 2. Press[ #]. (You can authenticate the password.) 3. Enter the administr

1. The administrator

password is authenticated. 2. Press 0. (The indicator turns green and makes a long beep.) 3. Press 0. (The indicator turns green and makes a long beep.) 5.Exit. (The device automatically exits the process when the operation is completed.) 4. The door is opened (The indicator turns green and makes a long beep.) Note: This function c

green, you can register the user again. Registered users must not be registered

again.  Register Cards in Batches 1. The administrator password is authenticated. 2. Press 6. (Registering Cards in Batches) 3. Swipe the first card once only. 5. Cards are successfully registered in batches. 4. Enter the total number of cards. 6. Exit. (The device automatic

1. The device is in the

authentication state. 2. Press fingerprints, swipe cards, or enter passwords. Press # after entering a password. 3. The authentication is successful. Yes Failed. (The indicator turns red and makes three beeps.) Note: Press # after entering a password for authentication. The door opens if the entered password is identical with one

Other IP Access Controllers Manuals