Tenmars TM201 Operation & User’s Manual

Text of Tenmars TM201 Operation & User’s Manual

Measures light from visible luminaries equipped with
fluorescent, metal halide, high-pressure sodium and incandescent sources. 2. SAFETY PRECAUTION Take extreme care for the following conditions while Do not operate the meter under the environment with explosive gas (material), combustible gas (material) steam or filled with dust. ln order to
Low cost highest precision.
Overload lndication: LCD will show "OL" in the left highest position. Low battery lndication. Sampling Rate: 2.5 times per second for digital display. Spectral response close to CIE luminous spectral efficiency. Cosine Angular corrected. According to JIS C 1609:1993 and CNS 5119 general A class Specif
Open the carrying case.
Press the "O" button to rurn power on or off Remove the cap of the light sensor, Put the light sensor at the spot where lhe testing of source of light is to be conducted, auto testing will then be conducted by the meter, read the testing value after the reading indicated becomes stable. When "OL
The deviation from the comparative standards for
luminosity is determined by JIS standard C 1609- 1 993. Peak sensitivity wavelength:550nm Typ. Ta=23t -v( 1) * - - - -TM-2O2 Tt\,1-205 WAVELENGTH (nm) *ClE luminous spectral luminous TEN ATTENTION set for referring the testing of source of light is located at the right top end
10. RECOMMENDED LEVELS OF
ILLUMINATION Suitable levels of illuminance (According to the JIS standard 29110-1979) Offices TCN 1 1. BATTERY REPLACEMENT Remove the battery cover Replace the battery. lnstall the battery cover. /l\ llf the svmbol "ffi" appeat, on the LCD. 4J lolease rLolace the batterv immediatelv 1. 2, .t. Illuminance (lux) Place 1 500 to 750 3f

Tenmars Measuring Instruments Owners Instructions: