Z-Wave Keyfob PSR03-A Manual 

Z-Wave Scene Remote PSR03- B Z-Wave Panic PSR03- C PSR03- A PSR03- B PSR03- C The Remote PSR03 is a simple control can control AV device through Z- Wave-to-IR extender, and it can also controls 8 lighting groups ON/OFF via basic set, based on Z-WaveTM technology. It is the Z-WaveTM plus product, it support the security, OTA... Those newest features of the Z-WaveTM technology. Z-WaveTM is a wireless communication ...

In the first time, activate the device through micro USB, then it can be added into the Z-WaveTM network. First, make sure the primary controller is in the add mode. And then power on the device. The device will auto start the NWI (Network Wide Inclusion) mode. And it should be added in 5 seconds. You will see the LED light ON one second. Function Description Add 1. Have Z-WaveTM Controller entered add mode. 2. Hold down ...

There are two group-buttons that can be switched by pressing central key. When the device is switched to group-button 1, LED will light on with red color for 3 seconds. When the device is switched to group- button 2, LED will light on with green color. PSR03-A has three keys on the device. The central one has panic function and the others can can control lock. PSR03-C has panic function. * AV Con ...

Lighting group 2 (Association group 3) Lighting group 3 (Association group 4) Lighting group 4 (Association group 5) Group-Button 2 Top-left Key Top-right Key Bottom-left Key Bottom-right Key Lighting group 5 (Association group 6) Lighting group 6 (Association group 7) Lighting group 7 (Association group 8) Lighting group 8 (Association group 9) Notice: For s ...

to the network? If doesn't, it will auto start the NWI mode. The LED will flash in every second and continue 30 seconds. Until timeout or the device successful to add by controller. Users can hold down the central key, then press the top-right key three times within 1.5 seconds to abort the NWI mode. Over The Air (OTA) Firmware Update The device support the Z-Wave firmware updat ...

Setting the BASIC command value to turn on the light. The 0xFF(-1) means turn on the light. For dimmer equipment 1 to 100 means the light strength. 0 means turn off the light. 7 (*) Customer Function 0 All    Customer function switch, using bit control. 0 Bit0: Switch AV control/Lighting group control. (0: AV control, 1: lighting group control) 0 Bit1: Reserve. 0 Bit2: R ...

0 means using the value of configuration 2 to set. NO. Name Def. Vali d Description Z-Wave Supported Command Class COMMAND_CLASS_ZWAVEPLUS_INFO_V2 COMMAND_CLASS_BATTERY COMMAND_CLASS_NOTIFICATION_V4 COMMAND_CLASS_ASSOCIATION_V2 COMMAND_CLASS_CONFIGURATION COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2 COMMAND_CLASS_VERSION_V2 COMMAND_CLASS_WAKE_UP_V2 COMMAND_CLASS_ASSOCIATION_GRP_INFO COMMAND_CLASS_POWERLEVEL COMMAND_CLASS_DEVI ...

(2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Warning Do ...