UTC RETAIL 3100 Series Installation Manual

11692017 Rev A  2009 UTC RETAIL. All rights reserved. 3100 Series POS Bundle 3100 Series POS Bundle Installation Guide Thank you for selecting UTC RETAIL’s innovative 3100 Series Point of Sale bundle solution! This guide is designed to help you efficiently assemble the 3100 Series POS Bundle System. ...

- 2 - © 2009 UTC RETAIL 3100 Series POS Bundle System Installation Guide This guide was prepared by UTC RETAIL to assist personnel with the installation of the bundle components. All attempts have been made to ensure that the information presented in this manual is correct. No liability, expressed or implied, will be assumed by UTC RETAIL o ...

3 11692017 Rev A TABLE OF CONTENTS 3100 SERIES POS BUNDLE SYSTEM INSTALLATION GUIDE .............................................................................................2 SAFETY PRECAUTIONS ............................................................................................................................................... ...

- 4 - © 2009 UTC RETAIL Product Information You will find the following components inside the 3100 Series POS Bundle System Box: • Safety Sheet • 3100 Series POS All-in-One unit (Touch Screen PC / logic device) • A/C power cord for logic device • Cash drawer • Barcode scanner • POS receipt printer • Keyboard • Mouse Note: The ...

5 11692017 Rev A Un-boxing the System 1. Open the point-of-sale box and remove the contents. 2. Remove all packing materials. Installation 1. Orient the cash drawer on its back side on your cash wrap (counter). Remove the keys. Locate the cash drawer cable package, labeled ‘APG cash drawer 320 Multipro cable kit’. Connect the end wi ...

- 6 - © 2009 UTC RETAIL 4. Connect the printer USB cable from the printer to any USB port on the rear of the 3100 Series. 5. Connect the power cable from the printer power supply to the connector on the printer. Connect the AC cable to the printer power supply and then to a wall outlet or the optional Power Conditioner. Optionally, connect c ...

7 11692017 Rev A 7. Connect the USB connector end of the Barcode Scanner cable to a USB port on the back of the 3100 Series. Connect the other end into the jack on the barcode scanner handle. Figure 5: Rear View of 3100 Series, Scanner connection 8. Connect the optional MSR (Magnetic Stripe Reader) assembly to the 3100 Series unit as foll ...

- 8 - © 2009 UTC RETAIL 3. Position the MSR Align the top and bottom grooves in the MSR unit with the guide rails on the LCD bezel and slide it into position, making sure the ground wire and data cable assembly are not pinched against the bezel wall. 4. Insert and tighten screws Insert the two screws provided with the MSR unit, and tighten to ...

9 11692017 Rev A 10. Connect the optional Rear Customer Display as follows: Figure 8: Side View of 3100 Series Unit 1. Remove the rear cover On both sides of the rear cover, remove the rubber plugs and the screws behind the plugs. From the rear of the machine, press in the tab on both sides of rear cover, unlocking the rear cover from the ...

- 10 - © 2009 UTC RETAIL 2. Remove the knockout Being careful not to scratch the cover, turn it over and hold it in your lap. Locate the plastic knockout and its tabs on the back side of the cover. Ensuring the knockout is not against your leg, and using a flat instrument, apply a slow, steady pressure on the knockout’s retaining tabs, whil ...