TESTO 606-1 Short Manual
Text of TESTO 606-1 Short Manual
Short manual testo 606-1
Protection cap: Park position
Sensing electrodes
Display
Control keys
Battery compartment (on rear)
Test resistance contact
List of settable materials, for
sticking into the protective cap
Basic settings
Instrument off > press and hold
2s > select with
(
),
confirm with
(
):
Auto off-Funktion: OFF, ON
Switching the inst
Safety and the enviroment
Safety and the environment
About this document
> Please read this documentation through carefully and
familiarise yourself with the product before putting it to use.
Keep this document to hand so that you can refer to it when
necessary. Hand this documentation on to any subsequent
users of the product.
> Pay particular attention to
Functions and use
The testo 606-1 is a material moisture measuring instrument. It
is normally used to determine the material moisture content in
wood or building materials. The measurement procedure used
is suitable for overview measurement to determine whenther the
material is continuing to dry out. The material moisture is give
At a glance
Protection cap: Park position
Sensing electrodes
Caution! Risk of injury
from sensing electrodes!
> Attach protection cap when
not in use.
Display
Control keys
Battery compartment (on rear)
Test resistance contact
List of settable materials, for
sticking into the protective cap
First steps
Inserti
Using the product
Using the product
To guarantee correct readings:
· Repeat the measurement at several points. The differing
resistance of the wood, with or across the grain, may have
an impact on the measurement result. If the injection needles
are inserted with the grain, this may result in slightly higher
readings because the resistance in the material
Using the product
> Press
several times until the desired material
characteristic curve appears.
Testing the instrument function:
1 Press
several times until Test: lights up.
2 Connect sensing electrodes with the contacts of the test
resistor on the top of the protection cap.
-
Test flashes.
-
Test: ok lights up: instrument is functioning.
Test: ok does n
Tips and assistance
Tips and assistance
Questions and answers
Question
Possible causes/solutions
Hi or Lo
· Readings outside the measuring range (too high, too ·
low): Readings outside the measuring range (too
high, too low): for materials that have not been
specially dried or moistened, the measurement
results should always be within the measuring range
What constitutes dry, or at risk, or damp?
The values indicated serve as guideline figures for assessing the
materials. The values are typical inner area values
Characteristic curve
Material
Dry
At risk
Damp /
very damp
Characteristic curve 1
or 2 inside heated
Beech, fir, larch...
< 12
12...15
> 15
Characteristic curve 1
or 2 inside unheated
Oak, pine, m