Panasonic KX-TD816 Installation Quick Manual

1.0 DECT Programming (PS Registration)........................................................................ 3 2.0 Site Survey.................................................................................................................7 Note This guide shows you the additional features for the DECT Portable Station (KX-TD7590) Plea ...

whose registration number is to be set are required for this programme. Selection (With a display PT) • PS registration number: KX-TD816 – 01 through 16 KX-TD1232 – 01 through 64 • PS extension number: 2 thr ...

The Cell Station (CS) may not be connected or not working. After connecting the CS or resetting the PBX, wait for at least one minute and try again from the beginning. 6. Press the POWER button for a while (about 5 seconds). 7. Press the FUNCTION button. 8. Press the FUNCTION button again. Or Press the UP/DOWN button rep ...

Display example: 19.If you select "ENABLE" in step 17, enter a System Lock password. 20.Press the AUTO/OK button. 21.Enter the System Lock password again. 22.Press the AUTO/OK button. 23.To programme another PS, press NEXT or PREV, or SELECT and the desired PS registration number. 24.Repeat steps 4 through 22. 2 ...

PASSWORD =---- 6. Enter a System Lock password and press the AUTO/OK button, if required. Display: DECT-SYS LOCK PASSWORD =**** 7. Go to steps 11 through 25 of the “Registering for the first time” programming. Conditions • You can assign an extension number to each PS also in programme, [671] PS Extension Number ...

1. Keep pressing , and until following message will be displayed. Display: FUNCTION (0-4)? 2. Press . • When the Cell Station ID Number is assigned, it is displayed on the bottom line. Display example: CS-ID SET CS NO.(0-7)? 3. Enter the Cell Station number (0 through 7). Di ...

. Deleting the assigned Cell Station ID Number on the PS 1. Keep pressing , and until following message will be displayed. Display: FUNCTION (0-4)? 2. Press . Display example: CS-ID CLEAR CS NO.(0-7)? (#=ALL CLEAR) 3. Enter the Cell Station number (0 through 7). Display ex ...

After assigning the Cell Station ID number to the PS, unplug the cable from the Cell Station once. DIP-Switch Setting After unplugging the Cell Station once, set the DIP-Switch as follows. 1. Switch the Radio Signal Test Switch from OFF to ON. 2. Set the Channel Number Switches as desired. 0 1 0 1 0 1 0 1 0 1 0 1 ...

needs to be set. • Up to eight Cell Stations can be surveyed at the same time. If more than one Cell Station is in Radio Signal Test mode, each DIP-Switch channel must be different. Connecting the AC Adaptor to the Cell Station After setting the DIP-Swit ...