NPK PH06 Instruction Manual

Text of NPK PH06 Instruction Manual

FOR UNDERWATER OPERATION

FOR HYDRAULIC HAMMER MODELS: “Use Genuine NPK Parts” © Copyright 2017 NPK Construction Equipment, Inc. www.npkce.com H035-9601G PH06-PH4,GH06-GH6,E202-E207 UWTR Instruction Manual 8-17 PH06 PH07 PH1 PH2 PH3 PH4 GH06 GH07 GH1 GH2 GH3 GH4 GH6 E202 E203 E204 E205 E207 7550 Independence Drive Walton Hills, OH 44146-5541 Phone (440) 232-7900 Toll-free (800) 225-4379 Fax (440) 232-6294

Safety notices in NPK Instruction Manuals follow ISO and ANSI

standards for safety warnings: DANGER (red) notices indicate an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING (orange) notices indicate a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION (yellow) notices indicate a potentially hazardous situation, which, if not avoided, may res

4. Fully extend the tool while charging the HAMMER with nitrogen gas. Be sure

that the retaining pin is installed. STAY CLEAR OF TOOL POINT WHILE CHARGING. 5. Do not disassemble a HAMMER before discharging the hammer gas pre- charge. 6. USE NITROGEN GAS ONLY! Store and handle nitrogen tanks per OSHA regulations. 7. Avoid high pressure fluids. Escaping fluid under pressure can penetrate the skin causing serious injury. Relieve pressure before

SAFETY ................................................................................................................ 1

OPERATING PRINCIPLE ..................................................................................... 5 AIR SUPPLY ......................................................................................................... 6 NPK UNDERWATER KIT LISTING ...................................................................... 7

The NPK HYDRAULIC HAMMER is a rugged boom mounted demolition tool that

can be operated underwater by making certain modifications and following the procedures in this manual. Read and understand the SAFETY INFORMATION and operating instructions in the NPK OPERATORS MANUAL before operating the hammer. If there are any questions, call the NPK Service Department at 1-800-225-4379.

Although the hydraulic oil section of the hydraulic hammer is sealed completely,

water can enter into the area where the piston (N) impacts the tool (HH) when the hammer is used underwater. The hammer must be modified for underwater operation. If not, water (107) trapped in the striking chamber (172) will be forced against the piston seals (PP) as the piston strokes (106) down to impact the tool. The water pressure is extremely high

NPK Tools Owners Instructions: