MICROTRONIX access 1000 series Quick Start Manual

Table of Contents 1 Overview.............................................................................................................................................4 1.1 Access X.25-TCP/IP Gateway models..........................................................................................4 1.2 WAN interfac ...

3.11.1 Device Settings..................................................................................................................................23 3.11.2 Network Settings...............................................................................................................................23 3.11.3 ...

1  Overview The Microtronix Access X.25–TCP/IP Gateway provides conversion between X.25 and TCP/IP devices, or X.25 encapsulation over TCP (XOT). In addition, raw synchronous and serial terminal servers may be configured. A web interface allows for configuration and monitoring from any Internet browser, and teln ...

The model name and serial number are printed on the label located on the bottom of the unit. The following sections describe the each attributes and function of each interface type. 1.2  WAN interface WAN ports support RS232/V.24 with speeds up to 128 Kbps, and V.35, X.21, RS530, RS449/V.36 interface types with sp ...

● USB flash drive for storing and moving files The 4002-S04 and 4002-N04-RM models may be specially ordered with an internally mounted USB flash drive with no external USB connector. The 4002-N44-RM models have an internally mounted USB 4-port serial expansion card. 2  Package Check List Check that the Access m ...

3  Quick Start Guide Configuration of the Access Gateway will require a PC or laptop with standard Internet browser like Internet Explorer or Mozilla Firefox. Optionally, a serial COM port (or USB serial adapter) on the PC with a terminal emulator application may be used to connect to the Console port. 3.1  In ...

set hostname MYNAME save boot These defaults will remain in effect until again changed again in U-Boot, or explicitly changed via the Ethernet configuration page in the web interface. 3.3.3  Emergency IP Address Recovery The u-boot console may be used to recover a forgotten IP address. While in the U-Boot con ...

3.4  Configuration Web Interface The default IP address of the Access Gateway is 10.1.1.240. The PC used to access the web interface must be configured (temporarily) for an address in the same subnet, for example, 10.1.1.200. Connect the PC to the same LAN, or temporarily use the red Ethernet crossover cable to ...

3.5  IP Network Configuration To create or modify the IP network parameters different than the default values defined in U-Boot , obtain the new IP address, network mask, and default gateway values. Follow this procedure only if you don't want the default values to be used in the running system. From the main me ...