Newhank D3000 Operation Manual
Text of the manual
Digital Power Amplifier
D Series Operation Manual
Model: D3000
ON/
OFF
POWER
-inf
0
-inf
0
-inf
0
-inf
0
-inf
0
-inf
0
D3000
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation opening. Install in accordance with the
manufacturer`s
Digital power amplifier D series have full protection function against
short circuit, direction current, over-load, over-heat and lower voltage.
The protection will help to prevent possible damage to the equipment
under the extreme situation.
1. Protection against short circuit
The protection circuit of the amplifier
Front Panel Introduction
1. Power On/Off Switch
PLS push down ON to turn on the power of the amplifier, push down OFF to turn off.
2. Air Vent
It is the vent for the heated air to flow through from inside of the amplifier. Pls do not
put any stuff inside or in the front of the vent to block the air flow.
LED Indicators
The user can know
Stereo (Dual) Wiring D3000
1. See the following figure. On the back panel, set the Output Mode Switch to STEREO.
2. Wire the speakers to the Speakon connectors as shown.
2+
3-
1
2-
2+
1-
1+
+-
+
-
+
-
+
-
+
-
CH1
CH2
CH2
CH1
220-240V~50/60Hz
CH3
CH4
OUTPUTS 3&4
1+
2+
1-
POS
NEG
INPUTS 3&4
BRIDGE
MONO
STEREO
P2
P3
P1
1+
1-
POS
NEG
POS
NEG
CH4
CH3
+
