Ohlins FGK 135 Mounting Instructions
Text of Ohlins FGK 135 Mounting Instructions
Ohlins FGK 135 Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00
fax +46 8 590 025 80
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
www.ohlins.com
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updat
© Öhlins Racing AB. All rights reserved. Any
reprinting or unauthorized use without the written
permission of Öhlins Racing AB is prohibited.
Printed in Sweden.
Safety Symbols
In this manual, mounting instructions and
other technical documents, important
information concerning safety is
distinguished by the following symbols:
The Safety Alert Symbol means: Warning!
Your safety is involved.
Warning!
The Warning Symbol means
How to install
1 - Remove Original Front Fork
5
2
Warning!
It is advisable to have an Öhlins dealer install the
front fork.
When installing, consult your Vehicle Service
Manual.
1
Put the motorcycle on a workstand so that
the front wheel barely touches the ground.
Warning!
Make sure the vehicle is securely supported so
that it will not tip.
2
Remove the front fender, brake caliper and
the front wheel.
3
Measure the position of the front fork:
Measure the
2 - Disassemble Original Front Fork
3 - Install Öhlins Front Fork Kit
2.1
Remove the original top cap from the fork leg.
2.2
Remove the original cartridge from the fork
leg.
2.3
Turn the fork legs upside down to pour out
all oil.
3.1
Remove the Öhlins top cap from the shaft.
3.2
Remove the spring support, spring and the
preload tube.
3.3
Put the cartridge into the fork leg.
3.4
Tighten the cartridge with tool 01797-07 to
torque 20 Nm. Smear some loct