Makita DHR280 Instruction Manual

If the lamp goes off after blinking for a few sec- onds, the active feedback sensing technology or the soft no-load rotation function is not working properly. Ask your local Makita Service Center for repair. NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. NOTE: If the dust collection system is installed on the tool, the lamp of the dust collection system lights up instead of the lamp of the tool. Reversing switch action 1 A B ►����1. Reversing switch lev ...

surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of elec- tric shock if your body is earthed or grounded. 3. Do not expose power tools to rain or wet con- ditions. Water entering a power tool will increase the risk of electric shock. 4. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 5. When operating a power tool outdoors, use an ...

1. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one�type�of�battery�pack�may�create�a�risk�of�fire� when used with another battery pack. 2. Use power tools only with specifically desig- nated battery packs. Use of any other battery packs�may�create�a�risk�of�injury�and�fire. 3. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to anot ...

switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge CAUTION: Always switch off the tool before installing or removing of the battery cartridge. CAUTION: Hold the tool and the battery car- tridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge�firmly�may�cause�them�to�slip�off�your�hands� and result in damage to the tool and battery cartridge and�a�perso ...

scaling or demolishing) The chisel can be secured at the desired angle. To change the chisel angle, rotate the action mode chang- ing knob to the O symbol. Turn the chisel to the desired angle. 1 ►����1. Action mode changing knob Rotate the action mode changing knob to the sym- bol. Then make sure that the chisel is securely held in place by turning it slightly. Depth gauge The depth gauge is convenient for drilling holes of uniform depth. Press and hold the lock button, and then insert the depth gauge into the hex hole. Make sure that the too ...

Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan Jan-Baptist Vinkstraat 2, 3070 Kortenberg, Belgium 885632B228 EN 20180601 ...