Magic-Pro MP-6VIP-C2 Operation & User’s Manual

MP-6VIP-C2 Motherboard User’s Manual Product Name: MP-6VIP-C2 Manual Revision: English, 1.00 Release Date: June, 2000 ...

This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: �� This device may not cause harmful interference �� This device must accept any interference received, including interference that may cause undesired operation. This equipment ha ...

Chapter 1: Introduction ..................................................4 1-1 CPU .............................................................................................. 4 1-2 CHIPSET ...................................................................................... 4 1-3 L2 CACHE ............................ ...

3-8 INTEGRATED PERIPHERALS ................................................... 42 3-9 SUPERVISOR / USER PASSWORD.......................................... 46 3-10 HDD AUTO DETECTION.......................................................... 47 3-11 S ...

1-1 CPU • Supports Intel FC-PGA 370 Celeron / Pentium III (Coppermine) CPU at 300MHz up to 750MHz or higher. • Supports VIA Cyrix III (Joshua) CPUs. • Supports CPU voltage auto-detect circuit. • Supports 66 / 75* / 83* / 100 / 103* / 112* / 124* / 133* / 140* / 150* MHz system bus speed. • Clock multip ...

• 2 high speed 16550A FIFO UART ports. • 1 parallel port with EPP / ECP / SPP capabilities. • PS/2 mouse connector and PS/2 keyboard connector. • Built-In RTC, CMOS, keyboard controller on single I/O chip. • Peripherals boot function. (with ATX power) 1-7 OTHER FEATURES • ATX size 17.0cm x 30.5cm ...

133 SPEC. 1-8.1 MOTHERBOARD LAYOUT --- MP-6VIP-C2 • DEFAULT SETTING: Celeron 300/66MHz, Pentium II / Pentium !!! 450/ 100MHz. 1 3 JP5 1 3 JP4 3� � 1 JP2 1 3 JP3 1 3 1 3 JVGA1 JP6� JP7 1 3 JP12 1 ...

133 SPEC. 1-8.2 MOTHERBOARD LAYOUT --- MP-6VIP-C2X • DEFAULT SETTING: Celeron 300/66MHz, Pentium II / Pentium !!! 450/ 100MHz. 1 3 JP5 1 3 JP4 3� � 1 JP2 1 3 JP3 1 3 1 3 JVGA1 JP6� JP7 1 3 1 ...

1. Pull the lever sidways away from the socket, and then raise the lever up to a 90-degree angle. 2. Take note of the red circle as below picture. When insert the CPU into socket, you can find out there is a definite pin orientation for CPU and socket. SOCKET 370 Chapter 2: Hardware Setup ...

lever down to complete the CPU installation. SOCKET 370 ...