Labgear PSM114V Installation Instructions

Text of Labgear PSM114V Installation Instructions

Labgear UHF Variable Mastheads

PUH141 + PSM114V: UHF 470-862 MHz 4-way 12-16 dB comes with PSM114V PUH111 + PSM114V: UHF 470-862 MHz 4-way 16-24 dB comes with PSM114V These new technically advanced UHF antenna preamplifiers offer unparalleled combination of low noise, good input filtering and high output capability. The amplifier units consist of fully screened, sealed modules fitted with Type-f connectors. These preamplifiers come with a moulded ABS wea

Mount the amplifier on a vertical section of the mast below the antenna using the cable tie provided-fig 4

The amplifier will not be affected by proximity to the antenna, but reasonable clearance – about 300mm- should be maintained to avoid disturbing the antennas performance. Alternatively, the amplifier can be mounted be methods in figs 5 & 6. Signal connections Type-f connectors provide a reliable low-cost method of connection with exce

Mounting and ventilation

Fix the unit to the wall, skirting board, mounting board o similar hard surface. A ventilation gap of at least 25mm should be left around the front and sides of the unit. Do not leave the power unit resting on a carpet. Do not install the power unit where it may become smothered with curtains or other fabrics. When installing the power unit in a roof space ensure that it will not become buried in thermal insulation mat

Labgear Amplifier Owners Instructions: