IVIEW CZ-537-10X Manual 

Fast Dome Cameras Available Models: CZ-537-10X 520TVL 10X PTZ Camera CZ-533-4 650TVL Fixed 4mm PT Camera CZ-533-8 650TVL Fixed 8mm PT Camera CZ-533-12 650TVL Fixed 12mm PT Camera CZ-531-4 520TVL Fixed 4mm PT Camera CZ-531-8 520TVL Fixed 8mm PT Camera CZ-531-12 520TVL Fixed 12mm PT Camera ...

1.1 Safety Instructions .............................................................................1 1.2 Warnings ............................................................................................1 2 Feature ............. ...

security, urban roads, airport terminals and bus stations, and also are able to satisfy various demands from any square and activities occasion. 1.1 Safety Instructions  Make sure to read the user manual before using the product.  Always confirm to national and lo ...

* OSD menu; * Auto flip; * Proportional zoom; * Day & night function; * RS485 non-polarity to control; * 254 presets, support lens preset; * Protocol and baud rate auto detected; * Compatible 38*38 CCD with fixed focus lens; * Pan Speed: 0.5°~40°/ sec, Tilt Speed: 0.5°~20°/ sec; * 360° pan rotation, 90° auto flip, auto ...

Help Selection Ceiling Power Supply DC12V/2A 50Hz/60Hz Power ≤15W Pan Speed 0.5°~40°/ sec Tilt Speed 0.5°~20°/ sec Pan Range 360°continuous Tilt Range 0°~90° auto flip Preset 254 Pan Scan frame scan; 360° random scan; 360° continuous scan; Pattern 4 Cruise 3 OSD Menu Chinese/English IR ...

Setting address code before using the dome camera, it could be setup by the dip-switch or soft address. 3.2 Zoom/ Rotation Auto Match Technology The camera can adjust automatically pan tilt speed according to the zoom far or near, make sure easier to operate manual motion detection. 3.3 Auto Pan The operator pulls the l ...

The preset #99 is programmed to be recalled in sequence. This feature is called auto cruise. Call preset #99 to start preset #1 to #20 cruises, call preset #88, start preset #1~#10, call preset #89, start preset #11~#20 cruise. 3.8 Pattern A pattern is a saved, repeating, series of pan, tilt, zoom and preset functions that can be recalled w ...

RS485: Output RS485 signal, connect the camera. BNC Connector: Output Video Signal. 4. 3 Dip Switch Setup Dip Switch as follows: Notice: Dip Switch Address Setup see appendix I 5 Operation Note: The manual will refer to our CCTV tester to explain how to operate and control the camera. ...

When power on, the camera moves automatically from pan range to tilt range, after movement, pull the lens to the nearest and then to the farthest, make sure the camera is running in normal. After the display information disappeared, press direction key “Left” and “right” twice, the camera could auto detected the baud rate,p ...