Isotech 414 User Maintenance Manual/handbook

Annealing Furnace model 414 Iss.3 – 06/12 ANNEALING FURNACE MODEL 414 User Maintenance Manual/Handbook Isothermal Technology Limited, Pine Grove, Southport, PR9 9AG, England Tel: +44 (0)1704 543830 Fax: +44 (0)1704 544799 Internet: www.isotech.co.uk E-mail: [email protected] The company is always willing to give technical advice and assistanc ...

Annealing Furnace model 414 Iss.3 – 06/12 CONTENTS EMC INFORMATION...................................................................................................................................................................... 3 ELECTRICAL SAFETY ............................................................................................ ...

Annealing Furnace model 414 Iss.3 – 06/12 EMC INFORMATION This product meets the requirements of the European Directive on Electromagnetic Compatibility (EMC) 89/336/EEC as amended by EC Directive 92/31/EEC and the European Low Voltage Directive 73/25/EEC, amended by 93/68/EEC. To ensure emission compliance please ensure that any serial comm ...

Annealing Furnace model 414 Iss.3 – 06/12 HEALTH AND SAFETY INSTRUCTIONS 1. Read this entire handbook before use. 2. Wear appropriate protective clothing. 3. Operators of this equipment should be adequately trained in the handling of hot and cold items and liquids. 4. Do not use the apparatus for jobs other than those for which it was designe ...

Annealing Furnace model 414 Iss.3 – 06/12 GUARANTEE This instrument has been manufactured to exacting standards and is guaranteed for twelve months against electrical break-down or mechanical failure caused through defective material or workmanship, provided the failure is not the result of misuse. In the event of failure covered by this guar ...

Annealing Furnace model 414 Iss.3 – 06/12 CAUTIONARY NOTE ISOTECH PRODUCTS ARE INTENDED FOR USE BY TECHNICALLY TRAINED AND COMPETENT PERSONNEL FAMILIAR WITH GOOD MEASUREMENT PRACTICES. IT IS EXPECTED THAT PERSONNEL USING THIS EQUIPMENT WILL BE COMPETENT WITH THE MANAGEMENT OF APPARATUS WHICH MAY BE POWERED OR UNDER EXTREMES OF TEMPERATURE, AN ...

Annealing Furnace model 414 Iss.3 – 06/12 UNPACKING AND INITIAL INSPECTION Our packing department uses custom designed packaging to send out your unit, but as accidents can still happen in transit, you are advised, after unpacking the unit, to inspect it for any sign of shipping damage, and confirm that your delivery is in accordance with the ...

Annealing Furnace model 414 Iss.3 – 06/12 SPECIFICATION Voltage 220/240 V Power 1000 W Supply Frequency 50/60Hz Maximum Operating Temperature 1000°C Working Volume 450mm x 50mm dia approx. Dimensions Height 880mm Width 400mm Depth 620mm Weight (nett) 40kg ...

Annealing Furnace model 414 Iss.3 – 06/12 MODEL 414 ANNEALING FURNACE INTRODUCTION One of the duties of a calibration laboratory manager is to ensure that the S.P.R.T.’s used in the Laboratory are fully annealed and still within specification. Just using the thermometers within the laboratory will cause work-hardening to take place within th ...

Annealing Furnace model 414 Iss.3 – 06/12 ANNEALING FURNACE The Annealing Furnace has two independent control systems, one for temperature control and the other for over- temperature protection. The furnace uses a Eurotherm 2116 over-temperature cut-off controller. On these models RESET button is located below the over-temperature controller ...