Clay Paky IGLOO Instruction Manual

Text of Clay Paky IGLOO Instruction Manual

Congratulations on choosing a Clay Paky product!

We thank you for your custom. Please note that this product, as all the others in the rich Clay Paky range, has been designed and made with total quality to ensure excellent performance and best meet your expectations and requirements. Carefully read this instruction manual in its entirety and keep it safe for future reference. It is essential to know

Make sure all parts for fixing the equipment are in a good state of repair.

Make sure the point of anchorage is stable before positioning the equipment. The safety chain must be properly hooked onto the fitting and secured to the framework, so that, if the primary support system fails, the fitting falls as little as possible. If the safety chain gets used, it needs to be replaced with a genuine spare. • Minimum distance of illumi

INSTALLATION AND START-UP

1 2 3 6 5 4 6 5 4 1 2 3 1 Mounting brackets for projector placement - Fig. 1 The dedicated brackets replacing the side handles should be mounted before inserting the projector in the IGLOO: C61192 - fast fit bracket for ALPHA 300/700/800 C61191 - fast fit bracket for SHARPY UNPACKING AND PREPARATION 099115 WARNING: to avoid damaging the projector, use the screws supplied with the bracket unit and not the ones previously re

Projector placement - Fig. 2

Once placed in the igloo the projector is fixed to the base by tightening the screws using 1/4 turns secured to the brackets.

Connecting to the control signal line (DMX) - Fig. 4

Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic impedance, 22-24 AWG, low capacity. Do not use microphone cable or other cable with characteristics differing from those specified. The end connections must be made using XLR type 3 or 5-pin male/female connectors. A terminating plug must be inserted into the last fixture into the Iglo

• GREEN LED ON: DMX board power on

5 1 1 2 4 8 16 32 64 128 256 512 ON 2 3 4 5 6 7 8 9 10 1 1 2 8 ON 2 3 4 5 6 7 8 9 10 1 ON 2 3 4 1 ON 2 3 4 • RED LED On Bootloader Off No DMX signal Relay OFF Slow flashing DMX signal found Relay OFF Fast flashing No DMX signal Relay ON Mixed flashing DMX signal found Relay ON • YELLOW LED Off Not assigned to a transmitter Mixed flashing Assigned to a transmitter and no DMX signal On Assigned to

Clay Paky DJ Equipment Owners Instructions: