Blankom QAMOS-CT Device Manual

Transmodulator QAMOS-CT Part no. 5120.01 8x DVB-C /-T /-T2 → DVB-C (8x QAM) Device MANUAL ...setting signals ...

2. Device variants ...............................................................................................................................................4 3. Software options ....................... ...

11. Application example ...................................................................................................................................32 12. Technical data ............ ...

1. Savety and operating instructions When assembling, starting-up and adjusting the modules, it is necessary to consider the system specific references in the instruction manual. The modules may only be installed and started up by authorized technical personnel. Only the mounting styles descr ...

4.1 Front view input coupler "input 1" LED "input 1" input coupler "input 2 / output" LED "input 2 / output" power connectors, operating voltage 12 V DC status LEDs "POWER" / "SYSTEM" status LEDs "CH1 ... CH8" control port incl. LEDs status LED "LOOP" output coupler "input" "RESET" button output coupler "output" 4. ...

4.3 LEDs at the input jacks Color Status Meaning of the display green constant satellite signal port has been configured as input, works properly amber constant satellite signal port has been configured as output (only port “IN/ OUT“) flashing LNB overcurrent (e.g. by short circuit) and/ ...

To use all functions of the module activate Java Script in your browser settings. Settings via checkbox are applied immediatelly, but not stored in memory! So they would be lost on a possible restart of the module. To save these settings the “send“ button must be pressed. Please send and store your settings by pressing ...

7.2 Setting of individual parameters Here you can set certain parameters of the module or perform configurations. The various setting menus can be selected in the navigation tree on the left side. The setting is supported by an online help. If you mouse over a parameter explanations of this pa ...

This page provides an overview of the 8 channels. "SYNC" is diplayed if a channel works correctly. If an error occurs or the channel is off a corresponding message is shown. The interface of the A-QAMOS MUX is separated for the multiplexer and QAM output. If a channel works correctly, "MUX" resp. "QAM" is displayed in a green color. ...

7.2.2 Menu „Input” In this menu the adjustment of the up to 8 tuners is done to receive the required programs. Port 1 (IN) is always configured as an input, Port 2 (IN / OUT) can be configured as input or loop-through output. Each port can be equipped with an input attenuation of 15 dB. N ...