Cisco S190 Quick Start Manual

www.cisco.com Cisco S190 Web Security Appliance Quick Start Guide • Welcome • Before You Begin • Document Network Settings • Plan the Installation • Install the Appliance in a Rack • Plug In the Appliance • Temporarily Change Your IP Address for Remote Access • Connect to the Appliance • Power Up the Applianc ...

• Cisco Notification Service Welcome Thank you for choosing the Cisco S190 Web Security Appliance (Cisco S190). The Cisco S190 helps organizations secure and control web traffic. This guide describes how to physically install the Cisco S190 appliance and use the System Setup Wizard to configure basic settings. You can also ref ...

Before you begin, write down the following information about your network and administrator settings. Deployment Options • Web Proxy – Transparent with L4 – Switch Transparent with WCCP Router – Explicit Forward Proxy • L4 Traffic Monitor – Simplex tap/Span port – Duplex tap/Span port Network Context Is there ...

IP Address: Network Mask: Hostname: Note The Web Proxy can share the management interface. If configured separately, the Data interface IP address and the management interface IP address cannot share the same subnet. Routes Internal Routes for Management D ...

Device Type: • Layer 4 Switch or No Device • WCCP Router – Enable standard service ID (web-cache). – Router Addresses: _________________ – Enable router security. Password:  _________________ Note When you connect the appliance to a WCCP router, you might need to configure the Web Security appliance to ...

Decide how you are going to configure the Cisco S190 Web Security Appliance within your network. The Cisco S190 appliance is typically installed as an additional layer in the network between clients and the Internet. Depending on how you deploy the appliance, you may or may not need a Layer 4 (L4) switch or a WCCP router to direct cli ...

always be configured inside the firewall and before NAT (Network Address Translation). If your installation includes multiple Cisco Web Security Appliances (S-Series) or Cisco Email Security Appliances (C-Series), you may want to also use a Cisco Content Security Management Appliance ( ...

Install the Cisco S190 Web Security Appliance using either the slide rails or fixed rack mount brackets. For information about these installation options, see the Cisco x90 Series Content Security Appliances Installation and Maintenance Guide. Appliance Placement in a Rack • Ambient Temperature—To prevent the appliance ...

Plug the female end of the power cable into the power supply on the back panel of the appliance. Plug the male end into an electrical outlet. Temporarily Change Your IP Address for Remote Access To remotely configure the Cisco S190 using the network connection, you must temporarily change the IP address of your computer. Alternatively ...

• IP Address: 192.168.42.43 • Subnet Mask: 255.255.255.0 • Default Gateway: 192.168.42.1 Step 8 Click OK and Close to exit the dialog box. For Mac Step 1 Launch the Apple menu and choose System Preferences. Step 2 Click Network. Step 3 Select the network configuration with the green icon. This is your active co ...