Cisco Cisco ASA Series Getting Started

• Access the Console for the Command-Line Interface, page 1 • Configure ASDM Access, page 9 • Start ASDM, page 15 • Factory Default Configurations, page 16 • Work with the Configuration, page 24 • Apply Configuration Changes to Connections, page 28 • Reload the ASA, ...

ciscoasa> This prompt indicates that you are in user EXEC mode. Only basic commands are available from user EXEC mode. Step 3 To access privileged EXEC mode, enter the following command: ciscoasa> enable The following prompt appears: Password: All non-configuration commands are available in privileged E ...

the ASA application. Subsequent connections automatically connect to the ASA application, so you can skip the following command. connect asa Example: Firepower# connect module 1 console Firepower-module1> connect asa asa> Step 2 Access privileged EXEC mode, ...

For initial configuration, access the command-line interface by connecting to the switch (either to the console port or remotely using Telnet or SSH) and then connecting to the ASASM. This section describes how to access the ASASM CLI. About Connection Methods From the switch CLI, you can use two methods to c ...

configure a Telnet login password on the ASASM (there is no default password). After you set a password using the passwd command, you can use this method. Note Benefits include: ◦You can have multiple sessions to the ASASM at the same time. ◦The Telnet session is a fast con ...

ciscoasa passwd: Example: Router# session slot 3 processor 1 ciscoasa passwd: cisco ciscoasa> For a switch in a VSS, enter the switch argument. The session slot processor 0 command, which is supported on other services modules, is not supported on the ASASM; the ASASM does not have a processor 0. To view the module sl ...

Ctrl-Shift-6, x You return to the switch prompt: asasm# [Ctrl-Shift-6, x] Router# Shift-6 on US and UK keyboards issues the caret (^) character. If you have a different keyboard and cannot issue the caret (^) character as a standalone character, you can temporarily or permanently change the escape ch ...

configuration mode, enter exit repeatedly until you exit the Telnet session. You return to the switch prompt: asasm# exit Router# You can alternatively escape the Telnet session using the escape sequence Ctrl-Shift-6, x; this escape sequence lets you ...

opening console session with module wlan connected to module wlan. Escape character sequence is ‘CTRL-^X’ ap> Step 2 See the Cisco IOS Configuration Guide for Autonomous Aironet Access Points for information about the access point CLI. Configure ASDM Access This section describes how to access ASDM with a default c ...

DHCP so that your management station can be assigned an IP address in this range. ◦ASAv—You set the management client IP address during deployment. The ASAv does not act as the DHCP server for connected clients. ◦ASA on the Firepower 9300 chassis—All ...