ESI ESPREE Assembly And Operation Manual

Text of ESI ESPREE Assembly And Operation Manual

ASSEMBLY AND OPERATION

ESPREE Model 2ESP-C48-ADJ-___ Model 2ESP-C60-ADJ-___ ___ = SLV, BLK or WHT PNEUMATIC TABLE BASE 2ESP Rev A 1/17

ESPREE PNEUMATIC TABLE BASE

PARTS AND TOOLS PLEASE REVIEW these instructions before beginning the assembly procedures. Check that all the parts shown below were provided with your order. Contact your supplier if any materials are missing. Do not discard the packaging until satisfied that the product operates to your satisfaction. ADDITIONAL TOOLS REQUIRED • #2 and #3 Phillips screwdriver • Power drill and 1/8" drill bit PARTS AND TOOLS PROVIDED Fram

ESPREE PNEUMATIC TABLE BASE

STEP 1 Lay the tabletop face down on a soft, clean surface. Center the frame assembly with the release cable facing the front. STEP 2 Raise the top table leg to the vertical position. • Align the holes on each side of the leg column with the holes in the frame channel. WARNING: Do not remove the safety pin or the safety ring until the table is fu

ESPREE PNEUMATIC TABLE BASE

ASSEMBLY STEP 6 Repeat steps 2 through 5 for the other leg column. • Raise leg to the vertical position. • Loosely attach frame support bracket with four M8x14 screws (again, with the long side of the support bracket toward the front of the table). • Tighten the pivot screws on each side of the frame channel. • Tighten the four M8x14 screws to 7 ft.-lbs. WARNING: Do not activate the release lever until the table is com

ESPREE PNEUMATIC TABLE BASE

STEP 8 Attach a foot to each of the legs. Refer to the illustrations. • The left side foot is attached with four M8x15 screws using the 6mm Allen key. • The right side foot is attached with three M8x15 screws and one M8x25 screw. The M8x25 screw fits into the threaded insert on the leg column. Tighten it with a 5mm Allen

ESPREE PNEUMATIC TABLE BASE

ASSEMBLY Cable Adjustment Nut STEP 12 With the assistance of a helper, turn the table upright and place it in its final position. IMPORTANT: There must be 1" (25mm) of clearance on all sides of the work surface (and other moving parts) to ensure free, unobstructed movement. • Adjust the leveling glides on the feet to level the work surface, if necessary. STEP 13 Test operation. • Place the contents on the table that have b

ESPREE PNEUMATIC TABLE BASE

OPERATION IMPORTANT: When adjusting the table, always make sure area is cleared of any obstructions or pinch points. • Pull the release lever toward you with one hand and using the opposite hand to raise or lower the table. WARNING: The table may suddenly raise upward or fall downward when the release lever is pulled. The table is designed to be balanced when the weight of the work surface and its contents is at th

ESI Indoor Furnishing Owners Instructions: