Erreka SMART-D201 Quick Installation Manual

Electric Lock 24Vdc Key Selector Push Botton LED Display LED1 System Learning LED2 RF Learing LED3 Photocell 1 LED4 Photocell 2 ransformer Batteries recharger incorporated in control board, no need to connect extra recharger. Maximum batteries capacity connection is up to 15Ah. The battery housing on the box is prepared for 2 batteries of 1.3 Ah. Batteries connection SMART-D201( M ) Quick Installation Guide MSA-114/04 (+) (-) (+) (-) ...

2 For example: How to set the Function “F1-2”; the steps are following: (1) Press the “SET” button for 3seconds, the LED will display F1. (*) To enter “F2” Function or another Functions, press the “UP” button to adjust F2 ~ F8. 1. Step Operations LED Display after the Step (2) After completin ...

you press the button again. (B) In gate-closing phase: the gates stop if the transmitter/push button/key selector is activated, and open when you press the button again. (C) In gate-opening or gate-closing phase: For safety purpose, the gates stop if encountering obstacles. Step1: Set the F ...

light for the proper Function. NOTE (Parameter F9) Exterior Photocell: Only be activated in case of door closing. Interior Photocell: Can be activated in door opening and door closing.. Complete programming chart (1) Encoder/ Limit switch Number of operators Maximum trapping force Gate speed Slowdown Soft stop speed Lapse between l ...

Note (Parameter F3) Please set F3 Function after system learning. The LED display 10 to indicate all of the recorded values will increase 1 ampere as the over current value. In other words, the LED shows 20 to indicate all the recorded values will increase 2 ampere as the over current value. The value can be adjusted by pressing button UP and DOWN. The maximum value is 40(4.0A) and the minimum value is 05 (0.5A) LED Display ...