Lectrosonics SMV-941 Instruction Manual
Text of the manual
Super Miniature Variable Power Transmitters
With Digital Hybrid Wireless® Technology
SMV-941
Single Battery Model
SMQV-941 Dual Battery Model
INSTRUCTION MANUAL
Rio Rancho, NM, USA
www.lectrosonics.com
Fill in for your records:
Serial Number:
Purchase Date:
US Patent 7,225,135
Digital Hybrid Wireless®
US Patent 7.225.135
The SM Series variable power transmitters are the
product of many years of engineering and experience in
professional audio markets. The unique design provides
several distinct features for professional applications:
• Selectable output power to maximize battery life or
operating range as needed
• Superb, comp
Super-Minature Belt Pack Transmitter
Rio Rancho, NM
3
Table of Contents
Introduction ............................................................................ 2
General Technical Description ............................................. 4
Controls and Functions ........................................................ 6
LCD Screen .........................
Variable 1.8 - 4v
+6V
+5V
5V
Regulator
Servo Bias Input
The voltage and current requirements of the wide vari-
ety of electret microphones used in professional appli-
cations has caused confusion and compromises in the
wiring needed for wireless transmitters. To address this
problem, the unique Servo Bias input circuit provide
Super-Minature Belt Pack Transmitter
Rio Rancho, NM
5
Signal Encoding and Pilot Tone
In addition to controlling the limiter, the DSP also en-
codes the digitized audio from the A/D converter and
adds an ultrasonic pilot tone to control the squelch in
the receiver. A pilot tone squelch system provides a reli-
able method of keeping a receiver output muted (au
Controls and Functions
LCD Screen
The LCD is a numeric-type Liquid Crystal Display with
screens for adjusting power, frequency, audio level and
low frequency audio roll-off. The transmitter can be
powered up with or without the RF output turned on. A
countdown appears in the LCD when powering on and
off, allowing the transmitt
Super-Minature Belt Pack Transmitter
Rio Rancho, NM
7
Battery and Battery
Eliminator Installation
Note: Standard zinc-carbon batteries marked
“heavy-duty” or “long-lasting” are not adequate.
The battery status circuitry is designed for the voltage
drop over the life of lithium batteries.
To install new batteries:
1. Turn the battery cover plate thumb
Power Up and Boot Sequence
1) Ensure that good batteries are installed in the unit.
2) Simultaneously press and hold the AUDIO and
FREQ buttons until the power on boot sequence is
initiated.
The count will progress from 1
through 3 and the unit will then
power up with the RF output
turned on. During this