General MMD950 Operation & User’s Manual

Text of General MMD950 Operation & User’s Manual

PIN/PINLESS DEEP SENSING

MOISTURE METER WITH SPHERICAL SENSOR AND REMOTE PROBE USER’S MANUAL MMD950 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com

TABLE OF CONTENTS

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 – 4 Key Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 What’s in the Case . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Setup Instructions . . . . . . . . . . . . . . .

Thank you for purchasing General Tools & Instruments’ MMD950 Pin/Pinless

Deep Sensing Moisture Meter with Spherical Sensor and Remote Probe. Please read this user’s manual carefully and thoroughly before using the meter. The MMD950 is designed for use in woodworking, water damage restoration, building construction and home renovation. Examples include: • Checking for moisture on or below the surface of carpets and sub- flooring • Mea

2. Locating the source of a water leak above a ceiling, by comparing the

REL readings at various points on it. If the ceiling is level, the point with the highest REL reading is below the source of the leak. The biggest advantage of the spherical sensor is its ability to sense moisture up to 4 in. below or behind the surface of a material. The remote probe’s pins can also sense moisture just below the surface of some materials. However, for hard material

The figure shows all of the controls, indicators and physical features on the

front, bottom, top, back and right side of the MMD950. Familiarize yourself with their positions and functions before moving on to the Setup Instructions. A. Spherical sensor B. Measurement mode indicator (REL shown) C. Indicates beeper is enabled D. Indicates battery is weak E. Jumbo LCD display F. Five-function Mode button G. Four-function button H. Battery/s

To power on the meter, press the

button and hold it for at least three seconds. (To power off the meter, follow the same instruction.) By factory default: • The beeper is enabled, and beeps faster the higher the readout above 17%WME in pin measurement mode (17 in REL mode). • The auto power off function is enabled, and activated by 3 minutes of front-panel inactivity. • The backlight is on. • Manual calibration checking (see

press the spherical sensor against a material known to be completely dry. This

should produce a reading of 0 on both the LCD and LED bar graphs. Then press the spherical sensor against one or more points on the target surface and compare the readings. Some measurement tips: 1. The spherical sensor’s accuracy is not affected by its angle relative to the target surface. Press the sphere against the material at the angle that makes the LCD easiest to read.

General Measuring Instruments Owners Instructions: