Anchor NAV50-1204 Operation & User’s Manual

Text of Anchor NAV50-1204 Operation & User’s Manual

50’ Wide System

Quality, Craftsmanship and Service since 1892 NAV50-1204 Copyright © Anchor Industries 2004 Please read all assembly / installation instructions before the installation or removal of this product. 1100 Burch Dr., Evansville, IN 47725 Ph. 812-867-2421 • Fax. 812-867-0547 E-mail: [email protected] • www.anchorinc.com Navi-Trac ANCHOR

TABLE OF CONTENTS

Page No. Assembly Step 2 Squaring Footprint and Laying out Uprights 3 50’ NAVI-TRAC component list and Hardware Location Chart 4 Introduction 5 50’ NAVI-TRAC Component Illustrations 6 NAVI-TRAC Installation Safety Guidelines 7 Construct End Module Top Frame 9 Install Hip End Fabric 10 Installing Uprights Under the Top Frame 11 Ten

DIRECTIONS FOR SQUARING THE TENT

1. USE A TAPE MEASURE TO MARK THE ENDS OF A LINE FOR ONE END (A TO B ABOVE) EQUAL TO THE EXACT WIDTH OF THE UNIT. 2. HOLD THE “0” END OF ONE TAPE AT POINT “A” AND THE “0” END OF ANOTHER TAPE AT POINT “B”. 3. EXTEND THE FIRST TAPE ALONG ONE SIDE OF THE UNIT TO A MEASUREMENT EQUAL TO THE EXACT LENGTH OF TH

50’ Navi-Trac Frame Terminology

INTRODUCTION: The NAVI-TRAC frame configuration is based on the hip roofed square tent shown at right. Hip bars connect corners to the peak, and rafters connect eave bars to the peak. The square can be extended into a rectangle by adding 10’, 15’ or 20’ bays made up of rafters and the appropri- ate ridge/eave bars (

Anchor Tent Owners Instructions: