ElectrIQ CD25PRO-LE Operation & User’s Manual

Air Purifier with UV and Plasma Ioniser Smart WIFI App and Remote Controlled CD25PRO-LE - 25 litres per day USER MANUAL Thank you for choosing ElectriQ Please read this user manual before using this innovative Dehumidifier and keep it safe for future reference Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals DISPLAY ...

10 Remote Control Features 13 How to Connect to WiFi 15 Positioning 16 Water Drainage 16 Care and Maintenance 18 Frequently Asked Questions 19 Troubleshooting 20 Technical Data 21 CONTENTS 01 ...

This appliance is only intended for use in an indoor domestic environment. Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to user or property. Rating: This unit must be connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about th ...

Avoid mishandling the dehumidifier. Dropping or throwing the unit can cause damage to its internals and increases the risks of operating it. Do not store or use gasoline, petrol, paint, solvents or other flammable vapours or liquids in the vicinity of this dehumidifier or any other appliance. This dehumidifier must not be used in spaces where there is a high concentration ...

not open windows or doors while the unit is running. Place the unit on a hard / flat surface. On first use run the unit continuously for 24 hrs. To reduce noise levels: Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit is running. CD25PRO-LE dehumidifiers use compressor technology to extract water from the env ...

PARTS Water tank Louvres Air outlet Control Panel Handle Castors Pre-filter/activated Carbon filter (Optional) Continuous Drain Port Power cord 05 ...

HEPA FILTER 6 stage dual action dehumidifier and purifier great in improving indoor air quality Antibacterial filter Polluted Humid air Clean dry air HEPA filter Activated Carbon filter Ioniser Dehumidifier UV light ACCESSORIES 06 ...

MODE Button Select the mode of the unit between: SMART / HIGH / LOW / and FAN. The unit will default to SMART mode the first time it is switched on and remains in this mode until another option is chosen. SMART Mode – Target humidity set to 50 – 55% relative humidity and the fan is automatically adjusted depending on current humidity l ...

There are three different options, 45, 90 degree and swing, the louvers will move in swing mode or be fixed in selected position. Use 45 degree or swing when using the Laundry mode. UV UV Light Button ( For air purification) To select "UV", press the "UV" button and the indicator light to the right of the button will illuminate. The germicidal UV light improves the air quality by destroying germs, bacteria, fungi. PLA ...

The led indicator performs the following functions: When the unit is plugged in - It will indicate the room humidity level When one of the humidity setting button is pressed - it will indicate the set humidity, before reverting to showing the current humidity after a few seconds When the timer button is pressed it will indicate in how many hours the timer function will operate, before reverting to showing the current ...

Swing control Button Press once to make the louvres swing and press again to lock at 45 degrees, press again to lock at 90 degrees. Do not operate the unit if the self- opening louvers do not open when the unit is powered on. Timer Button: Press the timer button then use buttons to adjust the timer (1-24 hrs, start/ stopping timer). In power on mode the set number will represent the ...

Setting the desired humidity to around 35% is good for a drying boost, on the units initial run, or in emergencies. It is not recommended to use it with these settings for normal operation in domestic/ office environment over a long period of time, as the air may become uncomfortably dry. For allowing more moisture in the air, press the humidity button to set to a highe ...

The red light will illuminate and the unit will beep when the tank is ready to be emptied, or if the water tank is incorrectly inserted. The water level control will shut off the dehumidifier until the empty tank is replaced in its proper position Auto Defrost The appliance will defrost automatically as programmed once the coil sensor detects temperature is too low in order to prevent ice building inside the unit. When frost builds up on th ...

measured away from the dehumidifier, the remote control contains many of the same buttons as found on the main unit, as well as a few other features. REMOTE CONTROL FEATURES DISPLAY OSC Mode UV ON/OFF Display (FAN) Ventilation (HIGH) Strong Dehumidification Laundry Auto UV light Ioniser Display louver swing angle Timer (LOW) Weak Dehumidification 13 ...

ON/OFF Button – Turns the dehumidifier on and off. Mode Button - Select the functions of the unit between: SMART / LAUNDRY / HIGH / LOW / and FAN. The mode selected will be displayed on the left hand side of the screen on the remote. The laundry function is only available through the remote, and sets the desired humidity to 35%, to ensure the maximum amount of moisture is removed from the air. OSC Button – Allows you to choose ...

Room temperature / humidity display – Your smart remote includes an inbuilt humidistat, allowing the humidity of the area to be measured from the remote. The humidity reading shown on the remote is the one measured by the remote, rather than transmitted from the dehumidifier. Please note: This sensor works on natural airflow, and as such it will take more time than the dehumidifier to reach an accurate reading. Due to this a ...

A badly positioned dehumidifier will have little effect. In positioning the dehumidifier please ensure circulation of the air in not restricted around the unit. At least 20 cm space should be allowed around the unit. This dehumidifier is designed for indoor residential / small office applications only and any commercial or industrial use will invalidate the warranty. Use the dehumidifier in an enclosed area for maximum efficien ...

avoid the water dripping into the unit and causing damage. Only empty the water tank when it is full or before moving or storing the unit. Do not rest the tank on the floor because the bottom of the tank could be uneven and tank may fall and cause the water to spill. When you remove the tank, do not touch sensors or any parts which are situated behind tank. Doing so may d ...

dehumidifier water outlet. Be sure to run the water pipe downward and let the water flow out smoothly. Do not kink or bend the pipe. NOTE: When the continuous drain feature is not being used, reverse the pipe installation, to start the water collecting in the water tank. The permanent drain can be used in conjunction with a water pump (e.g. when draining from a cellar) to ...

Every few weeks, clean the tank to prevent growth of mould, mildew and bacteria. Partially fill the tank with clean water and add a little mild detergent. Swish it around and than empty the tank and rinse. NOTE: Do not use a dishwasher to clean the tank. After cleaning and drying the tank must be reinserted securely into dehumidifier in order to restart operation. End of Season Maintenance： 1. Empty and clean the water tank. 2. Clean ...