Danfoss VLT 5000 Operating Instructions Manual

■ Contents Safety ...................................................................................................................... 3 Safety regulations ..................................................................................................... 4 Warning against unintended start ............................................. ...

Special functions ............................................................................................ 79 Local and remote control ........................................................................................ 79 Control with brake function ................................................................................... ...

Safety 175ZA438.18 VLT 5000 Series Operating Instructions Software version: 3.7x These Operating Instructions can be used for all VLT 5000 Se- ries frequency converters with software version 3.7x. The software version number can be seen from parameter 624. CE and C-tick labelling do not cover VLT 5001-5062, 525-600 V units. These Operating ...

The voltage of the frequency converter is dangerous whenever the equipment is connected to mains. Incorrect installation of the motor or the frequency converter may cause damage to the equipment, serious personal injury or death. Consequently, the instructions in this manual, as well as national and local rules and safety regulations, must ...

Safety 175ZA439.21 Warning: Touching the electrical parts may be fatal - even after the equipment has been disconnected from mains. Also make sure that other voltage inputs have been disconnected, such as external 24 V DC, load-sharing (linkage of DC intermediate circuit), as well as the motor connection for kinetic back-up. Using VLT 5001- ...

■ Introduction to Quick Setup This Quick Setup will guide you through EMC correct installation of the frequency converter by connecting power, motor and control wiring (fig. 1). Start/stop of motor is to be done with the switch. For VLT 5122 - 5552 380 - 500 V, VLT 5032 - 5052 200 - 240 V AC and VLT 5042-5602, 525-690 V, please refer to T ...

Quick Setup ■ 2. Electrical Installation, power NOTE: The terminals are detachable on VLT 5001 - 5006, 200 - 240 V, VLT 5001 - 5011, 380 - 500 V and VLT 5001 - 5011, 525 - 600 V Connect the mains supply to the mains terminals L1, L2, L3 of the frequency converter and to the earth connection (fig. 5-8). Cable relief fitting is placed on th ...

■ 3. Electrical installation, control leads Use a screw driver to remove the front cover under the control panel. NOTE: The terminals are detachable. Connect a jumber between terminals 12 and 27 (Fig. 10) Mount screened cable to external start/stop of control terminals 12 and 18. Fig. 10 ■ 4. Programming The frequency converter is progr ...

Introduction ■ Available literature Below is a list of the literature available for VLT 5000. It must be noted that there may be deviations from one country to another. Supplied with the unit: Operating instructions ....................................................................................................................... MG.5 ...