Atari Lynx II Manual 

Text of Atari Lynx II Manual 

ATTENTION ! Installing the LCD replacement is on your own risk! Your LYNX-II could be damaged,

if you are not able to do this modification! Liability impossible! Required materials: LYNX-kit, VGA connector with screws, 18 wires round about 20 cm (8 inches) length (IDE cable) 1. Step: Remove not needed Parts and 5 Volt check ATTENTION ! Make sure that all power is off. Disconnect ALL cables. 1. Remove VR1 trim potentiometer (if VGA connector is needed) 2. R

3. Step: Power and backlight button

Now solder one wire to VCC (+5 Volt) and one wire to GND (Ground). The wire of the backlight has to be soldered to U11 (74HC74A) on pin 2. Power (VCC and GND) !!! ATTENTION !!! Don't damage the flexcable (FPC) of the LCD ! You may disconnect the FPC, but don't forget connecting it correct after soldering GND. BACKLIGHT - pin 4 on the right If you DON'T want to install the VGA connector you can solder 1 wire from MENU p

Atari Game Console Owners Instructions: