Bard CompleteStat CS9B-THOA Installation And Operation Manual

INSTALLATION, OPERATION & QUICK START GUIDE Bard Manufacturing Company, Inc. Bryan, Ohio 43506 www.bardhvac.com Manual: 2100-684 Supersedes: NEW Date: 3-20-18 CompleteStatTM Controller Models: CS9B-THOA CS9B-THOCA CS9BE-THOA CS9BE-THOCA ...

TABLE OF CONTENTS INSTALLATION ........................................................3 Mounting Controller ............................................ 3 CompleteStat Setup Information .......................... 4 BASIC OPERATION .................................................5 Basic Setup ................................. ...

IMPORTANT: For optimum temperature sensor performance, the Bard CompleteStat must be mounted on an interior wall and away from any heat sources, sunlight, windows, air vents, air circulation obstructions and/or any other cause of erratic or false temperature sensing. Thermostat covers are not recommended as they interfere with m ...

CompleteStat Setup at Time of Installation Determine the following information prior to installation. 1. Degrees Scale: °F °C 2. Unit Type: A/C HP 3. Options: A/C – 1H/1C 2H/2C 1H/2C 2H/1C HP – 1 Stage 2 Stage 4. Economizer: Yes No 5. Fan: Off Delay ...

BASIC OPERATION BASIC SETUP These instructions are intended to provide the basic settings to get the equipment started. FIGURE 2 CompleteStat Buttons and Home, Overide and Configuration Screens Navigate the menus and change settings by pressing a combination of the four arrow buttons and the ENTER button. • ENTER button to sele ...

6. Press UP or DOWN button to choose °F (Fahrenheit) or °C (Celsius). Press ENTER to save selection of scale. NOTE: The change from F to C will not take effect on the home screen until the 24VAC power is cycled off and back on. 7. Press DOWN button to scroll to UNIT_TYPE. Press ENTER button. 8. Press UP or DOWN button to choose ...

12. Press UP or DOWN button to toggle ENABLE/ DISABLE. Press ENTER button to select/save choice. 13. Press DOWN button to scroll through additional DEHUMIDIFICATION screen choices: • ALLOW HTG DEHUM = Allows dehumidification in heating: YES/NO (default is YES). • DEHUM SETPT = Relative Humidity (RH) setpoint: 45% RH to 80% R ...

If COMP LOCKOUT was chosen during the heat strip configuration process, an optional outdoor air temperature sensor will have to be installed/ configured to specifically set the temperature at which the compressor will no longer be allowed to operate. Refer to the latest version of CompleteStat Controller Advanced Programming & Fe ...

Reversing Valve Setup 1. Press LEFT button two (2) times to return to ADDITIONAL SETUP. 2. Press UP or DOWN buttons to scroll to VALVE (see Figure 11). NOTE: VALVE does not show up on first screen. Continuing to press the UP or DOWN button will display VALVE. 3. Press ENTER button to highlight choice of ACTIVE HTG or ACTIVE CLG. ...

6. Press UP or DOWN buttons to enter appropriate heating setpoint. Press ENTER button to save new heating setpoint. 7. Follow the steps provided above to adjust cooling and heating setback temperatures, dehum setpoint and span, and CO2 setpoint and span of control in parts per million (if available). 8. Press LEFT button to retu ...