TA D-LOGG Manual 

Text of the manual

Table of contents

Hardware / General information ........................................................................................... 4 Power Supply / Slide Switch ................................................................................................ 4 Data line ..............................................................................

Hardware / General information

Power Supply / Slide Switch When the data converter is connected to at least one controller (DL), the slide switch on the converter must be in the "DL" position (left)!! Otherwise, problems with data logging can occur. The data converter receives the power it requires from the controller, regardless of whether it is connected

 With the UVR1611 controller, output 14 (DL) can be used as both a data connection and

a control connection. For data logging, output 14 must therefore always be configured as data line via the "Outputs" menu.  UVR1611 – Controllers from version A2.16 additionally allow network input variables to be logged (NETW.IP.=>DL.: yes), which is then

The USB driver is required for USB communication between the PC and D-LOGG and it cre-

ates a virtual COM port on the PC for this purpose. The driver must be installed on the PC for this (see "Installation") and is automatically load- ed when a D-LOGG is connected to the PC. The required drivers can be installed from the homepage http://www.ta.c

Configuring the virtual COM port

Memory Manager supports COM ports COM1 – COM6. If the virtual COM port that has been allocated to the driver during installation is not supported by Memory Manager, the driver can be manually allocated to another, still available port. For a PC with an internal modem, it should be noted that COM3 is usually used for this

Winsol (from version 2.03)

The Winsol program is used for the acquisition and evaluation of measured values recorded by the data logger. To be able to capture the data from several systems or data loggers, Winsol enables the creation and management of "Customers". General toolbar Deletes the logger data store Reads the data stored in the logger Set

Selection of the data logger, interface, specification of the logger configuration and entry of

the device description and the logged values takes place in the menu "File \ Setup". "Next" is used to switch forward to the next setup window, while "Cancel" is used to cancel setup without changing the logger configuration. 1. Window: Dat

Selection of the connection to the data logger

As the D-LOGG has no Ethernet interface, only the serial interface is enabled for selection of the COM port. "Test" checks communication with the logger at the selected inter- face. Information about the connected logger is displayed. "Apply" is used to specify the logger type in Setup. If the COM por

Other Media Converter Manuals