Emperor CWT-5500 Manual 

Text of the manual

Table of Contents

1. Location of controls on Camera 2. Location of controls on Monitor 3. Connections/Setting up 4. Specfications 1 2 3~7 8~9 Camera Transmitter: 1. Transmit Frequency: 2400~2483MHz 2. Microwave Output Power: 94 dBu FCC/10mW(BZT) 3. Modulation: FM 4. Maximum Frequency Deviation: 20 MHz 5. Audio Sub, Carrier Frequency: 5.5 MHz, 5.74 6. Infrare

Location of controls on camera

2 3 4 6 8 7 9 1. Patch Antenna 2. Infra-red Lighting 3. Wide-angle Camera Lens 5. Off/On/Night Switch 4. Microphone 6. Wall Mount Lug 7. Channel Selector Switch 8. DC Input Jack 9. Audio/Video Input 1 5 Specifications General: 1. Operation Frequency: 2400MHz - 2480MHz 3. Video: a) Input Impedance: 1 Vpp 75 ohm b) Frequency Resp

2. 5 inches/12.5cm CRT

1. Patch Antenna 3. Power Indicator 4. Off/Audio/Video Switch) 5. Contrast Control 6. Brightness Control 7. Volume Control 8. Speaker Location of controls on monitor 9. Channel & timer selector 10. DC Input Jack 11. Audio/Video Output 12. V-Hold Control 7 Audio Function: Connections/setting up When the Monitor is switched to "Audio" po

1. Remove the battery cover as

shown below. 2. Insert (or remove) the 10 size "C" batteries as below. Note: Install batteries as shown by the battery compartment marking only.. AC Adaptor Use: Make sure that proper AC adaptors have been installed correctly. Use only t

To prevent speaker and Microphone

feedback noise, the Monitor should be placed far enough away from the Camera. If the picture rolls up or down, the V-Hold control located on the back of the Monitor needs to be adjusted. Once you have a clear and crisp picture displayed on the screen, you can adjust the brightness and contrast by using

Other Security System Manuals