Berkel X13 Service Manual

X13 SLICER X13 X13A X13E X13AE - NOTICE - This Manual is prepared for the use of trained Berkel Service Technicians and should not be used by those not properly qualified. This manual is not intended to be all encompassing. If you have not attended a Berkel Service School for this product, you should read, in its entirety, the repair procedu ...

SERVICE UPDATES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 UPDATES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

PRODUCT TABLE ADJUSTMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 INTERLOCK CABLES / SUPPORT ARM ADJUST ...

X13 SLICER - SERVICE UPDATES F25332 Rev. A (0718) Page 4 of 36 ...

in this manual will apply to all models unless specified. Pictures and illustrations will be of model X13A unless otherwise noted. All of the information, illustrations and specifications contained in this manual are based on the latest product information available at the time of prin ...

Auto Clip Assembly (-) South out Timer Assembly (+) North out Sharpener (+) North out Index Mechanism (-) South out Use another magnet on the slicer to verify polarity of a replacement magnet. (Opposites attract) X13 SLICER - GENERAL F25332 Rev. A (0718) Page 6 of 36 ...

SHARPENER Sharpener Removal Disconnect the electrical power to the machine and follow lockout / tagout procedures. 1. Press down on lower tab. Fig. 1 2. Remove sharpener. 3. Reverse procedure to install. 4. Check slicer for proper operation. Sharpener Disassembly NOTE: Remove only those parts required to access part(s) being ...

goes under lip (4) on sharpener frame upon reinstallation. 4. Reinstall sharpener on slicer. 5. Check for proper knife sharpener operation. PRODUCT TABLE Product Table Removal Disconnect the electrical power to the machine and follow lockout / tagout procedures. 1. Place product table in home position and tu ...

Pusher Arm Removal Disconnect the electrical power to the machine and follow lockout / tagout procedures. 1. Remove product table as outlined under PRODUCT TABLE. 2. Remove two guide rail screws. NOTE: Do not allow guide rail to rotate while removing the screws. Fig. 6 3. Remove pusher arm assembly from guide rail. 4. Turn pusher handle ...

cable out (to the right). 6. Remove screw and washer securing other end of slide bar. 7. Remove slide bar (noting orientation for reinstallation). 8. Push in tab and lift flex cable to disconnect (X13A, X13AE). Fig. 10 9. Remove screws and square rail. NOTE: Reposition arm assembly and remove botto ...