JVC RX-ES1SL Instructions Manual

Text of the manual

HOME THEATER RECEIVER

AMPLI-TUNER CINEMA MAISON RX-ES1SL INSTRUCTIONS MANUAL D’INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear, bot- tom or side of the cabinet. Retain this information for future reference. Model No. Serial No. English Français

Warnings, Cautions and Others/

Mises en garde, précautions et indications diverses CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash wi

Table of Contents

Parts identification ............................................................2 Getting started ..................................................................4 Before installation ................................................................................ 4 Checking the supplied accessories ............................

See pages in parentheses for details.

1 Standby/on buttons (11, 34 – 37) AUDIO, DVD , VCR , DBS , TV 2 Source selecting buttons (11) DVD, VCR, DBS, TV, DVD MULTI, FM/AM 3 CHANNEL +/– buttons (34 – 37) 4 TV VOL (volume) +/– buttons (34, 37) 5 • Operating buttons for video components (34, 36) 4, 3, ¢, 1

button and STANDBY lamp (11)

2 DIMMER button (14) 3 SETTING button (16, 17, 19) 4 ADJUST button (21, 28, 30, 31) 5 SURROUND button (28, 30) 6 Display window (see below) 7 Source indicators DVD MULTI, DVD, DBS, VCR, TV, FM/AM 8 • SET button (16, 17, 19, 21, 29, 30, 31) • TUNER PRESET button (24) 9 Remote sensor (4) p SO

Putting batteries in the remote control

Before using the remote control, put two supplied batteries first. 1 Press and slide the buttery cover on the back of the remote control. 2 Insert batteries. Make sure to match the polarity: (+) to (+) and (–) to (–). 3 Replace the cover. If the range or effectiveness of the remote control

• If the AM loop antenna wire is covered with vinyl,

remove the vinyl while twisting it as shown on the right. • Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception. Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna. Connecti

Connecting the speakers

Turn off all components before connections. Speaker Layout Diagram After connecting the front, center and surround speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 15 to 18. Connecting the front, center, and surround

Other Receiver Manuals