Rowe BC100 Update Instructions

Text of the manual

Rowe BC100/BC150 Update Kit Installation Instructions

KIT CONTENTS Control Board with yellow printing Metal Slide Plate – short wide mouth Wiring Harness – main power to P1 of board Wiring Harness – to empty lamp on front door to P5 on left hand side of board = empty Wiring Harness – to Coin Dispense Assembly to C2 of board Wiring Harness – to Mars

not changed. The upgrade kit does not hold any coins in escrow, so the metal escrow

flaps connected to the bucket solenoids are removed. FLAP REMOVAL INSTRUCTIONS There are three black rods on the bucket assembly. Remove the e-clip on either side of the assembly from each of the two rods that have e-clips on the outside of the assembly. Push the rods in t

22. Reinstall the modified Coin Dispenser Assembly and secure it with the 3/8” bolt.

23. Reinstall the coin chute with the two ¼” screws. 24. Connect the new Coin Dispenser Assembly harness to header C2A of the new board. Run the harness up through the left rear hole and connect it to the Coin Dispenser Assembly. 25. Mount the hopper into the Coin Dispe

Drill an 11/64” hole in the black plastic area at the bottom of the hopper. The hole should

be located at the center of the hopper and 7/8” from the very bottom of the plastic. Positioning is important so that a coin does not get wedged between the screw and the hopper body. 4. Insert a screw through the hole. Reach your hand into the hopper and ali

The hopper LED lights while the hopper is running

The meter clicks once per dollar value at the end of the vend cycle Headers P1 and P2 are not used in this application; reserved for SBC2/SBC4. Dip Switch Settings AE2400 $1-$5 AE2600 $1-$20 VN2500 $1-$5 1. ON 1. ON 1. ON 2. ON 2. ON 2. ON 3. OFF 3. ON

Other Touch terminals Manuals