Team Electronic TeCom-PRO Freenet Manual 

FreeNet Funkgerät / Radio Bedienungsanleitung Manual TeCom-PRO TeCom-PRO VHF Betriebsfunkgerät Commercial Radio VHF Betriebsfunkgerät Commercial Radio ...

32 Squelch (05) 32 Scrambler (06) 32 Background Light On / Off (07) 32 Background Color (08) 33 Confirmation Tone On / Off (09) 33 ANI (Automatic Number Identifica ...

damaged, please contact your dealer immediately. Scope of Delivery: 1 x TeCom-PRO 1 x SMA-Antenna 1 x Battery Pack 1 x Charger-Mould and Adapter 1 x Belt Clip 1 x Manual Maintenance Please follow these instructions for your radios longevit ...

To remove the antenna turn the antenna counter-clockwise. Battery Pack To attach the battery pack to the radio, place the leading parts into the holes an the bottom of the radio. Next, press the battery pack at the upper ...

To inverse the transmission and receiption frequency, hold the frequency-inversion key [# T-R] for about 2 seconds. The letter R will be visible in the upper row of the LC display. To deactivate the frequency inverse function, hold the frequency inversion key [# T-R] unt ...

You can select between the TX powers HI and LO. The change of setting affects all channel. To change the transmit power for an individual channel see instructions for programming mode (step #8). In the freenet version, the programmed value for the low TX power (LO) is 300 mW and for the high TX power (HI) 500 mW. The TeCom-PRO has a maxim ...

following settings are available : OFF; 30s, 60s, 90s, 120s, 150s, 180s, 210s, 240s and 270s. To set the Time-Out-Timer open the menu by pressing the menu key [MENU] and turn the channel selector until the symbol „TOT ?“ appears in ...

The setup of this functions follows the aforementioned procedure, described in CTCSS/DCS RX-Code (18). +/- Shift Up (19) In the mode of the freely programmable frequency, the transmission frequency can be quickly shifted for 1 MHz up or down of the receiving frequency with this function. To shift the transmission frequency press ...

This function prevents transmission on occupied channels. The following options are available: OFF : Function deactivated 1 : Signal – Is a signal received, transmission will be blocked until the signal ends, regardless of the used code. 2 : CTCSS/DCS – Transmission is only blocked if the CTCSS/DCS code of the incoming sig ...

N/W ? Settings Bandwidth : NARROW/WIDE ENTER ENTER To store setting and leave menu press VFO/MR twice Channel Selector Channel Selector STEP? Settings Frequency Steps: 5/6,25/10/12,5/25kHz ENTER ENTER To store setting and leave menu press VFO/MR twice Channel Selector Channel Selector S-D ? Settings TX Shift : 0 ...