Monoprice 14567 Operation & User’s Manual

SAFETY WARNINGS AND GUIDELINES ....................................................................................................................................... 3 INTRODUCTION ................................................................................................................................................................................................ 5 CUSTOMER SUPPORT .............................................. ...

For best results, and to avoid personal injury or damage to your valuable equipment, carefully read and follow these safety warnings.  Do not expose this speaker to moisture of any kind. Do not place items containing liquids, such as vases or drinking glasses, on or near this speaker. If moisture does get in or on the device, immediately unplug it from the power outlet and allow it to fully dry before reapplying power. � ...

obsolete plug replaced.  Do not allow the power cord to be walked on or pinched. Do not run the power cord under a rug, as doing so could cause a fire.  Ensure that your AC power outlet provides voltage within the range specified on the rear panel of the subwoofer.  When removing cords or cables, do not pull on the cable. Always grasp the connector/plug head whe ...

deposits, moisten the cloth with warm water.  Do not use excessive volume when listening to this speaker. If you experience pain, discomfort, or dizziness, reduce volume immediately. Prolonged exposure to excessive volume can cause permanent hearing damage.  Do not disassemble or attempt to service this subwoofer. INTRODUCTION Congratulations on your purchase of thi ...

proper parts, as listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. 1x Subwoofer 1x AC power cord (IEC 60320 C13 to NEMA 5-15) 1x User's manual SUBWOOFER OVERVIEW 1. AC IN/FUSE: Plug the included AC power cord into this socket. The fuse holder has the main fuse and a spare inside. Check the SPEC ...

being sent to the satellite and center channel speakers. See the SETUP section below for details on how to use this control. 6. FREQUENCY: Use this knob to set the variable crossover frequency from 40 ~ 250 Hz. See the SETUP section below for details on how to use this control. 7. VOLUME: Use this knob to set the overall volume level of the subwoofer in relation to the sate ...

sounding bass.  Do not place the subwoofer directly against a wall or cabinet. There should be some room around the subwoofer for the sound to develop and reflect itself around the room.  Although bass is omnidirectional, a location in the front center is generally ideal. Tip: One good way to determine the best initial location for the subwoofer ...

single coaxial RCA cable from the amplifier's dedicated subwoofer output to the LFE input on the subwoofer. The next best connection type is from an amplifier's stereo preamplifier outputs to the two line level RCA jacks. The last connection choice is from the amplifier's stereo speaker level outputs to the stereo High Level Input on the subwoofer. The 5-way binding pos ...

1. Insert the black/negative side of one end of the cable into the black/negative Low Level Input RCA jack on the back of the subwoofer. 2. Insert the red/positive side of one end of the cable into the red/positive Low Level Input RCA jack on the back of the subwoofer. 3. Insert the black/negative side of the other end of the cable into the black/negative pre-ampli ...

including the subwoofer. Subwoofer Settings Auto Power: The amplifier features a power saving mode, which will automatically put the amplifier into standby mode after about 22 minutes of inactivity, then will automatically power on when an audio signal is detected. Use the POWER and AUTO switches to determine the mode of operation, as outlined below: Mode POWER ...

volume of the other speakers. The volume control on the subwoofer is therefore used to match the audio output level of the satellite and center channel speakers so that they blend into one smooth, continuous sound. In general, unless your musical material is particularly bass heavy or light, once you have set the volume on the subwoofer you shouldn't need to adjust it again. ...

F1AL250V fuse into the spare fuse tunnel. 6. Reinsert the fuse holder and push it in completely to seat it in place. 7. Using a Phillips screwdriver, remove the two screws holding the plastic cover over the Voltage switch, then remove the cover. 8. Using a flat head screwdriver, slide the Voltage switch to the 220~240 V~ position. 9. Replace the plastic cover over t ...

Amplifier Power (RMS) 100 watts into 4 ohms @ 1% THD+N Amplifier Power (Peak) 200 watts into 4 ohms @ 1% THD+N Nominal Impedance 4 ohms Frequency Response 40 Hz ~ 1.3 kHz THD+N (@ 100 watts/4 ohms/100Hz) 0.5% Signal to Noise Ratio > 96dB Line Input Sensitivity 205mV Adjustable Low Pass Crossover 46 ~ 250 Hz Low Pass Filter 270 Hz @ 30 dB/oct High Pass Filter 28 Hz @ 22 dB/oct Bass Boost 12dB ...

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifying the equipment without Monoprice’s authorization may result in the equipment no longer complying with FCC requirements for Class B di ...

This Class B digital apparatus complies with Canadian ICES-003. EU Declaration of Conformity Monoprice, Inc. declares the product described within this user guide or manual is in compliance with below applicable directives. The full text of the EU Declaration of Conformity is available at the following internet address: https://www.monoprice.com/product?c_id=109&cp_id=10906&cs_id=1090602&p_id=1456 7&seq=1&format=2 or the CE Do ...

Electric and Electronic Equipment (WEEE). This document contains important information for users with regards to the proper disposal and recycling of Monoprice products. Consumers are required to comply with this notice for all electronic products bearing the following symbol: For Consumers in the European Union: This EU Directive requires that the produc ...

swimming pool or in an area where accidental contact with water or liquid might occurs. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from the surge caused by lightning. WARNING: The external power adapter or AC power cord is the equipment's disconnection device. The power outlet must be located n ...