Tokyo Electronic CS8320B Technical Manual

the Image output at RESTART-RESET operation……………………………………………………. 9 3. Typical Examples of RESTART-RESET Operation………………� ...

phase within ± 5 µ sec. 2. Relation between the storage time and the Image output at RESTART-RESET operation (1) RESTART operation � Setting inside of the camera CONTROL BOARD S4-3 ; ON When RESTART-RESET operation, the signal stored during STORAGE A period can be ou ...

RESET point R. R Image output � FIELD STORAGE MODE RESET point R. R Image output (2) Slow speed shutter operation � Setting inside of the camera CONTROL BOARD S4-3 ; ON When slow speed shutter operation, the signal stored in STORAGE A period can be output during the period of IMAGING A as the below diagram. � FRAME STORAGE MODE R ...

R. R Image output 3. Typical Examples of RESTART-RESET Operation Random shutter operation, obtained one fame image, combined with RESTART-RESET and strobe light. � Setting inside of the camera CONTROL BOARD S4-3 ; ON The strobe light is flashed by R.R (reset point). And the signal stored while strode light flashed can be obtained at ...

RESET point RESET point R. R Strobe light Image output 4. SPECIAL SHUTTER (1) Relation between VD and readout timing Relation VD and readout timing (SO) in CS8320B/CS832OBC is as follows. The rising point of SG pulse comes to the timing to make the electronic shutter close. VD or R. R SG - 12 - Model Scanning field T 1st field 614.2 µ ...

� Setting inside of the camera CONTROL BOARD S4-4 ; ON * In case of operation with RESTART-RESET it requires to set S4-3. * When internal sync operation, HD/VD are fed from camera. The electronic shutter opens from approximately 2 µ sec. after the shutter trigger pulse rises up, and closes at the rising point of S ...

The method to make random shutter operation with frame image combined with RESTART-RESET and SPECIAL SHUTTER (But the image of the first field and the 2nd field is not the same time image.) � Setting inside of the camera S 4-3; ON CONTROL BOARD S4-4; ON By feeding and controlling the rising phases of shutter trigger a ...

RESET point RESET point R. R Shutter trigger Image output 5. Image Output in RESTART-RESET Operation When RESTART-RESET operation in CS8320B and CS8320BC, V. SYNC and V.BLK are not generated in the composite image signal right after R.R (reset point), one field period, but the phase relation between reset timing (VD) and the image outp ...

The internal stricture of this camera is as shown in the figure below. �Side view after opening the camera cover � Method of setting the different modes The different modes can be set using the switch S4 in the CONTROL board. The mode can be selected by moving the DIP switches 1 to 6 to the left or the right ...