RTMOTION LCS MK3.1 Operation & User’s Manual

& LATITUDE MDR LCS (Lens Control System) & Accessory Ecosystem User Guide REVISION: 2018-02-07 (#24) rtmotion.com/knowledge ...

1. Table of Contents 2 2. Quick Start Guide – Receiver MK3.1 3 3. Quick Start Guide – LATITUDE 4 4. System Overview 5 Theory of Operation 5 Usage Chart – MK3.1 7 5. Controller MK3.1 8 6. Receiver MK3.1 12 7. LATITUDE Devices 15 Standalone LATITUDE-MDR operating modes 17 8. MK3.1 Motor 20 9. Slave Controller – Thumbwheel 22 10. Sma ...

Initial Setup 1. Plug 12-17V into the RECEIVER's “PWR” port. The ideal source is a ~14.8V battery (i.e. 4S Lithium cells). If the voltage is over ~17.5V or polarity is reversed, the RECEIVER will block the dangerous voltage and not start. 2. Affix one or more MOTORS to the rods/lens. Each motor is factory-set to a c ...

Initial Setup 1. Plug 12-17V into the “PWR” port. The ideal source is a ~14.8V battery, such as 4S Lithium cells. 2. Affix MOTOR(s) to the rods/lens. Each motor is factory-set to a certain class (Focus, Iris, Zoom) and labelled accordingly. You can re-assign motor classes via the menu. 3. Plug the MOTOR(s) into the LATITU ...

Introduction The RTMotion Lens Control System is optimised for high-end Wireless and Wired remote control of Cinema and still camera lenses. The range is specifically designed to enable a low-cost entry point (single motor), with a broad expansion capability. A large number of accessories are in development to further expand on the range's ...

stay at the forefront of performance, and are proud to offer the longest range, most interference-immune wireless solution on the market. FCC and CE certification is of course retained, and we are now right up to the legal limit. Slave Controllers Slave Cont ...

The Controller MK3.1 gives from 4 to 6 axis control. Note: Picture shows MK3.1/Z variant (with Force-Zoom Joystick). Variants MK3.1/S, “Slider”. 4 AXIS CONTROL Large Focus Knob ​+​ Slider ​+​ 2x Side Knobs (A/B). MK3.1/Z, “Force-Zoom”. 6 AXIS CONTROL Large Focus Knob ​+​ Slider ​+​ 2x Side Knobs (A/B) ​+​ Force ...

Syncing If the Controller is new or has never paired to a Receiver/LATITUDE, then press; MENU... WIRELESS / FIND RECV (this will scan for active Receivers and automatically pair.) Camera Run/Stop Press the REC button to start recording. Press REC again to stop recording. Not ...

buttons. To go BACK one step, press MENU. To abort and pull out of the menu, press POWER. For a full breakdown of menu functions, see page . Default Configurations MK3/S “Slider” MK3/Z “Force-Zoom” Large Knob → FOCUS FOCUS Slider → IRIS IRIS F ...