Vega VEGABAR 82 Quick Setup Manual

Pressure transmitter with ceramic measuring cell VEGABAR 82 4 … 20 mA Document ID: 46305 ...

46305-EN-131125 Contents 1 For your safety 1.1 Authorised personnel ....................................................................................................... 3 1.2 Appropriate use ................................................................................................................ 3 1.3 Warning a ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 1 For your safety 1.1 Authorised personnel All operations described in this operating instructions manual must be carried out only by trained specialist personnel authorised by the plant operator. During work on and with the device the required personal protective equipment must always be worn. 1 ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 radiated�emissions�must�be�taken�into�account,�as�is�usual�with�class� A instruments according to EN 61326-1. If the instrument is used in a�different�environment,�the�electromagnetic�compatibility�to�other� instruments must be ensured by suitable measures. ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 2 Product description 2.1� Configuration The�nameplate�contains�the�most�important�data�for�identification�and� use of the instrument: 2 1 14 15 16 17 13 11 12 5 3 6 4 7 8 9 10 Fig. 1: Layout of the type label (example) 1 Instrument type 2 Product code 3 Field for approv ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 • Enter the serial number manually in the app ...

46305-EN-131125 3 Mounting 3.1 General instructions for use of the instrument Protect your instrument against moisture penetration through the fol- lowing measures: • Use the recommended cable (see chapter "Connecting to power supply") • Tighten the cable gland • Turn the housing in such a way that the cable glan ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 4 Connecting to power supply 4.1 Connecting The voltage supply and signal output are connected via the spring- loaded terminals in the housing. Connection to the display and adjustment module or to the interface adapter is carried out via contact pins in the housing. Information: The t ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 7. Check the hold of the wires in the terminals by lightly pulling on them 8.� Connect�the�screen�to�the�internal�ground�terminal,�connect�the� outer ground terminal to potential equalisation 9. Tighten the compression nut of the cable entry gland. The seal ring m ...

VEGABAR 82 • 4 … 20 mA 46305-EN-131125 5 Set up with the display and adjustment module 5.1 Insert display and adjustment module The display and adjustment module can be inserted into the sensor and removed any time. Four positions displaced by 90° can be se- lected. It is not necessary to interrupt the ...