Vanco EVMX4444 Manual 

EVMX4444 HDMI® 4x4 Matrix Selector Switch www.vanco1.com • 800.626.6445 HDMI® 4x4 MATRIX SELECTOR SWITCH ...

moisture, or excessive humidity. 2. Do not install or place this unit in a built-in cabinet, or other confined space without adequate ventilation. 3. To prevent risk of electrical shock or fire hazard, due to overheating do not obstruct unit’s ventilation openings. 4. Do not install near any source of h ...

sources to be distributed to up to 4 displays simultaneously. Have multiple sources displayed simultaneously on any display or have a single source duplicated on multiple displays, flexibility for the perfect solution. With an output bandwidth of 6.75 ...

Video Bandwidth ........................................................ Single-link 225Mhz [6.75 Gbps] Video Support ........................................................... 480i/480p/720p/1080i/1080p @60 36-bit color Audio Support . ...

2. Port 1-4: Input source channels mapping LED for each output channel 3. Port 1-4 Select: Push button for selecting input channels 4. Source Status: Input source indicator LED 5. IR SENSOR: IR sensor for receiving the IR commands from IR remote 6. LED: Power indicator 7. RS-232: RS-232 control port 8. Ethernet: Ethern ...

display and source. The EDID learning function is only necessary whenever any display on the HDMI output port is not outputting audio and video properly. Because the HDMI source devices and displays may have various level of capabil ...

REMOTE CONTROL 1. INPUT/OUTPUT Switch - Push the corresponding button on the remote to select Input & Output port. Ex: Select Input 2 to Output 3 - The button highlighted in the red circle button shown below to select Input 2 to Output 3 2. Function Key Button Function OFF Standby mode ON Power on the matrix switcher S ...

1) OS Information: MS WinXP/7 2) Baud rates: 9600 3) Software size: 3 MB 4) Minimum RAM requirement: 256 MB OPERATION CONTROL – Software control through RS-232 OPERATION CONTROL - SOFTWARE CONTROL THROUGH RS-232 AND ETHERNET PORT 1. I/O Routing Button 2. Rename I/O Button 3. EDID Button 4. Network B ...

I/O: Select the input Click “Send” to change the I/O setting Save Mapping: Select Mapping(1-8) Click “Save” button to save current mapping Preset Mapping: Select Mapping(1-8) Click “Recall” button to recall previous mapping which are saved ...