MXN MXN9500DD Owner's Manual

ALL ROUND VISION MONITOR Model: MXN9500DD Design and specifications are subject to change without notice. OWNER’S MANUAL PLEASE READ CAREFULLY BEFORE USING THIS PRODUCT. ...

OPERATION 04 SYSTEM SETTINGS 05 FUNCTION 05 PICTURE MENU 06 NORMAL/MIRROR 06 AUDIO 07 TRIGGER AUDIO 07 CAMERA TRIGGER 08 DISTANCE MARKER 08 MARKER 08 AUTO PICTURE SCAN 09 CAMERA NAME 09 SPEED SWITCH 10 MENU 11 SPLIT 11 TRIPLE 11 QUAD 12 MANUAL SELECTION 12 DISTANCE MARKER ADJUSTMENT 13 MENU LOCK ON/OFF FUNCTION 14 AUTO PICTURE SCAN ON ...

3 PACKAGE CONTENTS SUNVISOR MONITOR BRACKET REMOVER MANUAL BRACKET SCREWS CABLE CLIP ITEM Q’TY MONITOR 1 SUNVISOR 1 REMOVER 2 BRACKET 1 BRACKET SCREW 3 CABLE CLIP 2 MULTI-CABLE 1 MANUAL 1 MULTI-CABLE ...

4 OPERATION RIGHT SPEAKER POWER SELECT DOWN MENU DAY/NIGHT SENSOR (CDS) LEFT UP Press [RIGHT] button to adjust monitor volume. Use [RIGHT] button to change OSD setting during system setting. Press [POWER] button to turn on/off the monitor. Press [SELECT] button to select the respective camera channel. (CAM1 ...

5 SYSTEM SETTINGS DIMMER (Automatic Brightness Control) Select AUTO or OFF to have Automatic or Manual brightness of the monitor. REMARK: By activating DIMMER AUTO function, the monitor adjusts the brightness and button illumination according to the environment’s light conditionst. NIGHT BRIGHT Select the DIMMER to『AUTO』, set ...

6 SYSTEM SETTINGS Press [LEFT/RIGHT] button to adjust the PICTURE of the monitor. User can adjust picture setting values for CAMERA CHANNELS and AUX CHANNEL individually. Via PICTURE MENU, the picture of CAM1, CAM2, CAM3, CAM4, SPLIT, TRIPLE, QUAD MODE can be adjusted. Via AUX PICTURE MENU, the picture of a ...

7 During manual channel select the audio per channel can be selected ON or OFF individually. When the mode is [ON], audio will be on (activated) during manual camera selection. When the mode is [OFF], audio will be off (mute) during manual camera selection. AUDIO AUDIO CAM 1 AUDIO ON/OFF CAM 2 AUDIO ON/OFF CAM 3 AUDIO ON/OFF CAM 4 ...

8 TRIGGER 1/2/3/4 (Trigger source selection) Select the required trigger source: CAM1/CAM2/CAM3/CAM4/AUX/SPLIT/TRIPLE/QUAD REMARK TRIGGER PRIORITY: TRIGGER 1 > TRIGGER 2 > TRIGGER 3 > TRIGGER 4 In case DC power at all triggers at the same time, then Trigger 1 has highest priority. TRIG. DELAY When a TRIGGER ...

9 The scanning time of CAM1/CAM2/CAM3 /CAM4/AUX/SPLIT/TRIPLE/QUAD can be selected individually. REMARK If the SCAN TIME is set as [0], monitor skips its channel during the scanning. Press [UP] button for 4 seconds to ACTIVATE/INACTIVATE auto scanning function. CAMERA NAME can be selected as CAM1, 2, 3, 4/ REAR/ LEFT/ RIGHT/ FRONT. ...

10 The orange wire needs to be connected with the vehicle’s analogue tacho signal and via MENU the SPEED SWITCH needs to be selected ON. At FREQUENCY 67Hz setting (most common used tacho signal) the selected camera will be displayed during a speed of 0-33km/h. Select the concerning camera via『UNDER FREQ ...