Tesla WALL CONNECTOR Installation Manual

THIS MANUAL IS OF THE HIGHEST IMPORTANCE Approved Markets: China Mainland, Hong Kong 壁挂式连接器， 40A 单相电流 安装手册 该手册至关重要 经批准的市场：中国大陆地区和香港地区 壁掛式連接器， 40A 單相電流 安裝手冊 本手冊至關重要 經核準的市場� ...

All information in this document and all MODEL S® software is subject to copyright and other intellectual property rights of Tesla Motors, Inc. and its licensors. This material may not be modified, reproduced or copied, in whole or in part, without the prior written permission of Tesla Motors, Inc. and its lice ...

i TABLE OF CONTENTS IMPORTANT ! READ THIS ENTIRE MANDATORY DOCUMENT BEFORE INSTALLING OR USING THE WALL CONNECTOR. FAILURE TO DO SO OR TO FOLLOW ANY OF THE INSTRUCTIONS AND WARNINGS IN THIS DOCUMENT CAN RESULT IN FIRE, ELECTRICAL SHOCK, SERIOUS INJURY OR DEATH. THE WALL CONNECTOR MUST BE INSTALLED BY A DULY REGISTERED AND QUALIFIED ...

Safety Information SAVE THESE IMPORTANT SAFETY INSTRUCTIONS This document contains important instructions and warnings that must be followed when installing and maintaining the Wall Connector. WARNINGS The Wall Connector must be grounded through a permanent wiring system or an equipment grounding conductor. Do not install ...

2 Specifications The maximum rating for the Wall Connector is 10 kW or 40 amps at 220 volts. Your vehicle can charge from 180 to 265 volts. Voltage and Wiring 220V AC single-phase: LINE, NEUTRAL, and EARTH Current Maximum 50A circuit breaker Frequency 50 Hz Cable Length Approximately 7.6 m Wall Connector Dimensions Height: 385 mm Wi ...

Features OPTIONAL CIRCUIT RATINGS For the fastest charging, using a circuit breaker rated for 50 amps is recommended. SELF-MONITORING AND RECOVERY The Wall Connector has a ground monitoring circuit that continuously checks for the presence of a safe ground connection and automatically recovers from faults. Manual testing a ...

4 Service Wiring - Single Phase WARNING: The Wall Connector is a single-phase device. Do not connect all 3 phases of a 3-phase feed. WARNING: Before installing the Wall Connector, identify the type of utility service connection available on site. If you are unsure about the type of connection available at the service panel, consult ...

Installation Overview TOOLS REQUIRED Before installing the Wall Connector, ensure you have the following tools: • Pencil or marker • Drill and 8 mm drill bit • T20 torx driver • Hole saw, 32 mm • Sharp knife or razor • Phillips screwdriver • Wire stripper • Ratchet wrench with 8 mm and 17 mm sockets, and a ...