Panasonic DV-08VRE2 Installation Instructions Manual

Text of the manual

READ AND SAVE THESE INSTRUCTIONS

Thank you for purchasing this Panasonic product. Please read these instructions carefully before attempting to install, operate or service the Panasonic product. Failure to comply with instructions could result in personal injury or property damage. Please explain to users how to operate and maintain t

For your safety

Explanation of symbol word panels Denotes a potential hazard that could result in death or serious injury. Denotes a hazard that could result in minor injury. This symbol is used to alert users to a specific operating procedure that must not be performed. This symbol is used to alert users not to disassemble the equipments. To reduce the risk

GENERAL SAFETY INFORMATION CONTINUED

Extreme bending Prohibited Prohibited Prohibited Prohibited Floor 45° 45° Adaptor (Cooking area) Do not install above or inside this area Cooking equipment Bend repeatedly Duct narrow Bend near adaptor This product must be properly grounded. Make sure that the electric service supply voltage is AC 120 V,

Unpack and carefully remove the unit from carton.

Refer to the Supplied Accessories list to verify that all parts are present. Warning: This equipment must be installed by qualified person in accordance with the provided installation instructions; and all applicable codes and standards. Also, any changes or modifications not expressly approved by the party

Unit: inches (mm)

Adaptor Tape Damper 5 INSTALLATION (BETWEEN JOISTS MOUNTING) Fan body Red Motor White LED lamp Junction box Black Capacitor (114 °C Fuse in Motor) Thermally protected White White White White Earth ground White Neutral Neutral Live Live Black Black Green Green Black Black Power Supply AC 120 V

5. Hang the fan body down from the four long

screws, and adjust the suspension brackets if necessary. Then, tighten the four long screws up. And that, fix the other four long screws (ST4.2X20) to other holes. Make sure the fan body is level and square with the joists. (Fig. 4) 6. Tighten the two screws (ST4.2X6) up (Except that

1. Remove the trim ring by pulling down the mounting

springs. (Squeeze mounting spring and pull down carefully.) (Fig. 10) 2. Clean the trim ring. (Don’t put into hot water. Use non-abrasive kitchen detergent, wipe dry with clean cloth.) (Fig. 11) Fig. 11 Gloves Trim ring Fig. 10 Trim ring 2-Mounting springs Gloves Ceiling Fig. 9 2-Mounting

PRACTICAL GUIDE TO INSTALLATION

Properly insulate the area around the fan to minimize building heat loss and gain. (Fig.15) Loose fill or batt insulation can be placed directly over the fan housing in the attic. Our fans and fan/light combination units do not create excessive heat that is a common problem with recessed light fixtures or some compet

More Panasonic Fan Owners Instructions: