HP 5550C - ScanJet - Flatbed Scanner Manual 

Text of the manual

Before proceeding, read these instructions all the way through. Then return here and follow the steps in

order. This module is organized into the following sections: • preparation • disassembly • cleaning • reassembly preparation Tools needed: • flat-head screwdriver • phillips screwdriver Supplies needed: • Glass cleaner • lint-free cloths

remove the scanner lid

After steps 1 and 2 have been completed and the scanner has cooled for 15 minutes, you can remove the lid as shown. 3 Open the lid and lift it straight up. Scanner lid being removed 4 Set the lid aside.

Clean top of the scanner

Clean the outside of the scanner prior to disassembly to prevent contamination of internal parts. Use only glass cleaner. Avoid abrasives, acetone, benzene, and carbon tetrachloride, all of which can damage the scanner glass. Avoid isopropyl alcohol because it can leave streaks on the glass. Do not spray the glass cleaner directly on

Unlatch the top cover

Begin disassembly only after completing steps 1 through 6 You are about to expose the interior of the scanner to the dust of the outside environment. the scanner is very sensitive to dust; any dust particles that get into the carriage head can cause streaks in the scanned image. Minimize the time that the top cover is off by having all

9 Insert a flat-head screwdriver into the slot

on the back of the scanner. The slot is located above the ADF port between the top cover and the base. Pry the top cover up with a screwdriver. flat-head screwdriver being inserted between base and top cover remove the top cover After unlatching the top cover, you are ready to remove it. top cover being lift

Dust will immediately begin accumulating in your scanner now that the top cover is off.

Minimize the time the scanner base is exposed. Read all directions and have the necessary tools ready before removing the top cover. While the top cover is off do not leave the scanner unattended. Static discharge from your fingers, hand, or tools will damage the circuit

re-mount the top cover to the scanner

When you have finished cleaning the underside of the glass, reassemble the top cover. 12 Hold the top cover directly above the scanner and lower it into position as shown. top cover being lowered onto base 13 snap the back of the scanner together bus squeezing the top cover and the base together at the A

14 Holding the top and bottom covers

together, turn the scanner upside down on a clean surface. insert the screws 15 Re-insert and tighten the four screws with a Phillips screwdriver. Step #7 Insert the screws location of screws 16 Turn the unit over so that the glass side is facing up. insert the scanner lid you can now re-insert the scanner lid,

Other Scanner Manuals