Visonic MP-840 Installation Instructions Manual
Text of the manual
D-306082 MP-840 PIR ZB
1
�������
ZigBee Home Automation 1.2
Wireless Digital Pet Immune PIR Detector
�
Installation Instructions
����������������
The MP-840 (pet immune) is a microprocessor-controlled wireless digital PIR detector supported by H.A 1.2
panels using ZigBee Home Automation.
The detector’s featur
D-306082 MP-840 PIR ZB
WIRELESS
Supported Network
Frequency
ZigBee H.A 1.2
2.405 – 2.480 Ghz as per IEEE 802.15.4
Tamper Alert
Reported when a tamper event occurs and in any subsequent message, until the tamper switch is
restored
�
MOUNTING
Height
Installation Options
1.8-2.4 m (6 - 8 ft). For pet rejection, the optimal height is 2.1 m (7 ft)
Surface
D-306082 MP-840 PIR ZB
3
�
�
������#$����$ %����%"�!����
1.
Mount the bracket on the wall
2.
Press in the point marked “F” in the drawing and separate the cover from the base
3.
Insert the battery while observing polarity.
-OR-
If battery is already installed, pull the activation strip that protrudes from the fro
D-306082 MP-840 PIR ZB
�
�
�
�
������&%' �(�$)����$���#*�
Remove the plastic (pet mask) in case of no need for pet immunity
�
�
1. Place your thumb at the base of the Pet Mask.
2. Place your fingers at the top of the Pet Mask..
3. Lift the Pet Mask to remove.
�
Figure 9 – Removing the Pet Mask�
�
���
D-306082 MP-840 PIR ZB
5
��/��"$ '�$ �(���!��� � �(�$)����$�"$%��
To pair the detector to the control panel, you must set it to pairing mode.
1. First set the panel to pairing mode and then the detector.
2. To activate, pull the activation strip that protrudes from the back of the detector (see Figure 5). The devic
