Perle IDS-108F Installation Manual

Overview This document contains instructions necessary for the installation and operation of the Perle IDS-108F Ethernet switch. This Ethernet switch can be ordered as an 8-port RJ-45 switch or as an 8-port RJ-45 switch with one or two SC or ST fiber ports. The fiber ports can be either single mode (SM) or multimode ...

- 3 - Getting to know your IDS-108F Switch Package Contents: • IDS-108F • DIN-rail mounting clip (pre-installed on the unit) • This guide Note – Optional panel/wall mounting kits may be ordered for the IDS-108F Front View of IDS-108F (8 port RJ-45) ...

- 5 - Bottom view of the IDS-108F (with two ST fiber ports) Top view of the IDS-108F Specifications Terminal block Header (J1) – Cat. No. 5EHDR-04P, manufacturered by Dinkle Enterprise Co., Ltd. Rated 300 V, 15 A, 105°C, FW-1. Terminal block Plug – Cat. No. 5ESDV-04P, manufacturing by Dinkle Enterprise Co., Rated 300 V, 105° ...

Reset Button To reset the IDS-108F insert a paper clip into the air hole vent and gently press the reset button. The LEDs on the IDS-108F will go On and then momentarily Off when released to show that the unit has been reset. All links will be dropped and the MAC tables will be cleared. Status LED (with two fiber po ...

- 9 - Mounting the IDS-108F on a DIN-rail 1. The DIN-rail clip will be fixed to the back panel of the IDS- 108F switch when you receive the product. 2. Position the IDS-108F such that the top of the DIN rail fits into the slot on the top of the DIN-rail clip, just below the DIN-rail hook and behind the spring. 3. While pushing dow ...

3. Use the wall mount plates as a guide to mark the spots where the screws will be. 4. Drive the screws into the wall leaving about 2 mm of the screw protruding from the wall to allow room for sliding the wall mount panel between the wall and the screws. 5. Once the screws are fixed to the wall, insert the four scr ...