Perkins 2806C-E18TA Operation And Maintenance Manual

Industrial Engine JG1 (Engine) SEBU9074-01 (en-us) January 2017 ...

Most accidents that involve product operation, maintenance and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessa ...

Foreword ........................................................... 4 Safety Section Safety Messages............................................... 5 General Hazard Information.............................. 7 Burn Prevention................................................11 Fire Prevention and Explosion Prevention.......11 Crushing Prevent ...

lubrication and maintenance information. This manual should be stored in or near the engine area in a literature holder or literature storage area. Read, study and keep it with the literature and engine information. English is the primary language for all Perkins publication ...

your engine. The exact location and a description of the safety messages are reviewed in this section. Become familiar with all safety messages. Ensure that all the safety messages are legible. Clean the safety messages or replace the safety messages if the words cannot ...

Illustration 2 g03856817 Illustration 3 g03857446 6 SEBU9074-01 Safety Section Safety Messages ...

Illustration 4 g01370904 One safety message is on the left side of the engine. One safety message is on the right side of the engine. Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings ...

the engine while the engine is operating. • Do not attempt any repairs that are not understood. Use the proper tools. Replace any equipment that is damaged or repair the equipment. • For initial start-up of a new engine or for starting an engine that has been serviced, make provisions to stop the engin ...

must be below 205 kPa (30 psi). The maximum water pressure for cleaning purposes must be below 275 kPa (40 psi). Fluid Penetration Pressure can be trapped in the hydraulic circuit long after the engine has been stopped. The pressure can cause hydraulic fluid or items such as pipe plugs to escape rapidly if the p ...

low sulfur diesel fuel (ULSD fuel) poses a greater static ignition hazard than earlier diesel formula- tions with a higher sulfur contents. Avoid death or serious injury from fire or explosion. Consult with your fuel or fuel system supplier to ensure the delivery system is in compliance with fueling standard ...