PERGO F60 Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR PERGO DEVICE DEVICE OVERVIEW POINTS TO BE TAKEN INTO CONSIDERATION DURING THE FIXED INSTALLATION OF THE DEVICE PREPARING THE DEVICE FOR INSTALLATION Before beginning the fixed installation of the device into a vehicle, the SIM card to be used and the battery should be fitted into the device and o ...

consumption mode and shall shut itself down. After being turned on, the device must be checked at a time close to the automatic shut-down time, and whether only the red led blinks once every two seconds MUST be checked. Otherwise the installation must be discontinued. If the green and blue lit leds do not go out in more than ...

In order to perform the fixed installation of the device to the vehicle, it is necessary that at least 3 cables in the bunch of cables produced for the device should be connected to vehicle power. During assembly, the cable ends belonging to the device must under no circumstances be attached between the fuse legs on the vehic ...

knife, please take care not to get injured and do not force the socket of the device, cutting/breaking the socket completely. Please check whether or not the cable socket is fully connected to the socket in the Pergo device. The socket must under no circumstances be forced into place. The device must not be installed if the s ...

b. If the external power connection is correct, the green illuminated led in the centre shall light continuously. c. The blue illuminated led will light continuously because the vehicle ignition switch is on. d. If the Panic button is pressed, the red illuminated led will light continuously. The red illuminated led will go of ...

TROUBLESHOOTING 1. Blue (GSM/GPRS) illuminated led status a. If the blue led is continuously on; i. A SIM card may not be inserted. ii. The SIM card PIN code inquiry may not have been cancelled and may not have been recognised by the device. iii. The GSM Modem may be defective. In order to understand the exact reason of the ...